Abstract:For improving the friction properties of GH05 superalloy in high temperature and high pressure water environment, Cr/DLC and CrN coatings were prepared on the alloy surface via ion source assisted unbalanced magnetron sputtering and multi - arc ion plating respectively. FGD autoclave was used to conduct the high temperature and high pressure test of the coatings, and scanning electron microscope (SEM) was used to observe the surfaces and cross - sectional morphologies of the coatings. Moreover, a high temperature UMT tribometer and a step height tester were used to study the friction and wear properties of the coatings, and a nanoindenter was employed to measure the hardness and elastic modulus of the two kinds of coatings before and after high temperature and high pressure test. Results showed that the surface morphology and mechanical properties of the CrN coating after high temperature and high pressure test changed slightly in comparison with that before such test. However, the Cr/DLC coating suffered remarkable oxidation. The coating structure became loose, and the bonding force as well as the hardness of the coating significantly decreased. On the other hand, the high temperature and high pressure test led to an increase of the friction coefficient of Cr/DLC and CrN coatings in both dry and water environments, which might be attributed to the oxidation of the coatings’ surfaces and the deterioration of mechanical properties of the coatings. Compared with the sharp decrease of friction properties for the Cr/DLC coating, CrN coating still maintained good friction and wear properties after high temperature and high pressure test. Especially, the wear rate of CrN coating in water environment was only 1.40 × 10-7 mm3/N·m, which was only 1.60% of that of the Cr/DLC coating under the same test condition (i.e., 8.73× 10-6 mm3/N·m). Overall, the CrN coating could greatly improve the service performance of the superalloy under severe working conditions.

Abradability Evaluation of NiCrW-BN Gas Path Seal Coating

High-Temperature And High-Speed Abadable Tester For Abradability Test Of Seal Coatings

Evaluation of an AlSi-polyester abradable seal coating performance using high-temperature and high-velocity abrasion tests

High-speed Abrasion Experimental Research of an Abradable Seal Rubber

Investigation of High-Speed Abrasion Behavior of an Abradable Seal Rubber in Aero-Engine Fan Application

Scraping Morphology and Adhesion Morphology Analysis of Sealing Coating Based on Scraping Temperature

High-Speed Rubbing Behavior of Abrasive Coating Coated on Titanium Alloy Blade Tips

Investigation of High-Speed Rubbing Behavior of Labyrinth-Honeycomb Seal for Turbine Engine Application

Progress on Facilities and Methodology to Evaluate Abradable Seal Coatings

Tribological characteristics of WC-Cr3C2-Ni cermet coatings under different wear parameters

Comparative Study of Mechanical Performance of AlCrSiN Coating Deposited on WC-Co and cBN Hard Substrates

Study on salt spray corrosion and friction wear performance of CrN coated cemented carbide sealing ring

Study on the Friction Properties of Cr/DLC and CrN Coatings Before and After High Temperature and High Pressure Treatment

Friction Performance of EPDM Used for Seals in Different Working Conditions

Study on Frictional Performance of Mechanical Seal Spare Material Used for Nuclear Coolant Pump

Unveiling the influence of nickel on the erosion and the tribological performance of AlSi-based abradable coatings

Porous spheres enabling excellent high-temperature abradability and long lifetime for abradable seal coating

Friction and Wear Characteristics of Cr-CNTs Composite Coating End Faces of High-Temperature Mechanical Seals

Study on Friction and Wear Performance of Sliding Metal Seal Materials Under Reciprocating Motion

Analysis and Experimental Study on Friction and Wear Characteristics of Super High-Speed Mechanical Seal