Abstract:During petroleum drilling, the reciprocating motion in the seal device leads to piston and sleeve wear, which may cause leakage of the sealing medium. Selecting appropriate materials for the piston and sleeve, along with surface modifications, can effectively prolong the seal service life of the seal. The friction and wear properties of piston and sleeve pairs of different materials in a metal sealing device were simulated by the laboratory "pin-on-block" reciprocating friction test. Pins made of 45# steel, 35CrMo, and 20Cr13 were used to simulate piston bulges, while 35CrMo samples were used to simulate sleeves. Additionally, the influence of DLC (diamond-like carbon) coating and QPQ (Quench–Polish–Quench) nitriding on the wear resistance of the materials was studied. Based on this, the friction and wear properties, along with the wear mechanism of different material pairs, were analyzed. The results show that the friction coefficient curves of the three piston base materials and the 35CrMo sleeve are similar, and the friction coefficient of 45# steel is lower than that of 35CrMo and 20Cr13 at the initial stage. The DLC surface coating exhibited the best anti-wear performance, with the lowest friction coefficient, minimal wear, and the most stable friction coefficient. Surface QPQ nitriding treatment can also improve the wear resistance of the base material. However, due to the oxide formed during nitriding being prone to flaking, the friction coefficient fluctuates significantly at the initial stage of testing, and its anti-wear performance was inferior to that of the DLC coating. This study on material pairing and surface modification provides theoretical support for material selection and surface modification design of pistons and sleeves in oil drilling sealing devices.

Friction Performance of EPDM Used for Seals in Different Working Conditions

Tribological Properties of Seals in Integrated Transmission of Vehicle

Study on Frictional Performance of Mechanical Seal Spare Material Used for Nuclear Coolant Pump

On Frictional Performance of Sintering Materials Used by Mechanical Seals in Water

Study on Friction and Wear Performance of Sliding Metal Seal Materials Under Reciprocating Motion

Experimental investigation on frictional behavior and sealing performance of different composites for seal application

Analysis of Friction and Wear Properties of Friction Ring Materials for Friction Rings under Mixed Lubrication

Influence of diamond-like carbon coatings and micro-texturing on friction and wear of seal interfaces: Experiment and simulation study

Frictional performance of silicon carbide under different lubrication conditions

Interfacial friction evolution between DLC film and sealing NBR on the plunger of fracturing pump based on molecular dynamics simulation

Experimental study on seismic performance of laminated rubber bearings with friction slipping

Friction and Wear Behavior of Different Seal Materials under Water-Lubricated Conditions

Effect of Particle Size on Tribological Properties of Rubber/Steel Seal Pairs Under Contaminated Water Lubrication Conditions

Development of Friction Properties Experimental Device of Mechanical Seal Material in Vacuum Working Condition

Analysis and Experimental Study on Friction and Wear Characteristics of Super High-Speed Mechanical Seal

Sealing Performance of Adaptive Contacting Mechanical Seal

Theoretical and Experimental Characterization for Macro-Micro Friction Behaviors of EPDM Rubber

The Preparation and Frictional Performance of Electroless Ni-P-PTFE Composite Coatings on Mechanical Seals

Effect of load on the stick-slip phenomenon and wear behavior of EPDM

Friction and Wear Performance of Sliding Bearing Seat of Reactor Pressure Vessel

Abrasive wear behavior of PTFE for seal applications under abrasive-atmosphere sliding condition