Abstract:The pilot-operated electro-hydraulic proportional directional valve is widely used in complex and precision engineering fields. Its operational stability and reliability determine the overall performance of the hydraulic system. During the working process of the pilot-operated electro-hydraulic proportional directional valve, the spool is deformed due to the influence of pressure and temperature, resulting in problems such as clamping or stagnation. In order to solve this problem, this study uses the fluid-solid-thermal coupling simulation method to analyze the flow field characteristics and thermal deformation of the spool with different structural throttling grooves, and optimizes the U-shaped throttling groove structure. The results indicate that as the valve opening increases, the front section of the throttling groove becomes the primary region where the maximum radial deformation of the spool occurs. In this paper, the steady-state flow force of the valve core is taken as the measurement standard, the constraint range of the structural parameters is determined, and the radial thermal deformation is included in the optimization analysis of the structural size. It's verified that the optimized flow characteristics are improved by about 32 % compared with that before optimization, and the maximum steady-state flow force after considering thermal deformation is reduced by about 4N compared with that before optimization. This provides an important design basis and reference for the structural design and optimization of the pilot electro-hydraulic proportional directional valve.

Thermal-fluid-structure coupling analysis for valve plate friction pair of axial piston pump in electrohydrostatic actuator (EHA) of aircraft

FEM Based Simulation Study on Static and Dynamic Properties of Port Plate in Axial Piston Pump

Analysis on dynamic experimental system of lubrication film properties of friction pairs in axial piston pump

Simulation and Experiment on Static Characteristic of Water Hydraulic Proportional Pressure Relief Valve

Churning Losses Analysis on the Thermal-Hydraulic Model of a High-Speed Electro-Hydrostatic Actuator Pump

Analysis of the Cylinder Block Tilting Inertia Moment and Its Effect on the Performance of High-Speed Electro-Hydrostatic Actuator Pumps of Aircraft

Research on Fluid Dynamics and Thermal Characteristics in Hydraulic Valves by Thermal-Fluid-Solid Coupling Method

Tolerance Design Guideline for Piston/cylinder Interface of Electro-Hydrostatic Actuator (EHA) Pumps Based on a Thermal-Fluid-Structure Model

Comparative Study on Asymmetric and Symmetric Configurations of Valve Plates in Axial Piston Pumps

Thermo-Mechanical Coupling Analysis of the Actuating Mechanism in a High Speed Press

Effect of Surface Texture on Wear Reduction of the Tilting Cylinder and the Valve Plate for a High-Speed Electro-Hydrostatic Actuator Pump

Thermal Characteristic and Analysis of Electro-Hydrostatic Actuator

Effect of Piston-Slipper Assembly Mass Difference on the Cylinder Block Tilt in a High-Speed Electro-Hydrostatic Actuator Pump of Aircraft

Lubrication and Fluid Film Study on the Vane Tip in a Vane Pump Hydraulic Transmission Considering a Fluid and Structure Interaction

An Investigation into the Swash Plate Vibration and Pressure Pulsation of Piston Pumps Based on Full Fluid-Structure Interactions

Fluid-solid-thermal coupling analysis of an underwater valve

Life Cycle Assessment of a Slipper/swash Plate Friction Pair Based on Thermal-Fluid-structure Lubrication State Dynamic Recognition

Evaluation of the Viscous Heating Induced Jam Fault of Valve Spool by Fluid–structure Coupled Simulations

Simulation analysis and optimization of pilot type electro-hydraulic proportional directional valve based on multi field coupling

Fluid Dynamics Investigation on the Body Structure Inside a Sleeve Regulating Valve

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)