Abstract:This study aims to investigate the effect of tundish level control on the change in element content and inclusion amount in molten steel during the low tundish-level steel grade transition. Based on multiphase flow, mass transfer, and discrete phase, a three-dimensional transient numerical simulation of the tundish was established in Ansys Fluent. The model uses moving mesh refinement technology to obtain clear steel and slag interface with a small number of meshes. The numerical simulation results were verified through industrial experiments and physical simulations. The results indicate that when the tundish is at a low level, strand 3 becomes a short-circuit flow, and the number of inclusions in strand 3 is approximately four times that in strand 1. If the old grade density is higher than that of the new grade, the unqualified length of the element content in the transition billet is 10.2 m shorter than that in the opposite order. When the filling speed of the tundish is three times the normal flow rate, the length of the transition billet with an unqualified number of inclusions is 7.1 m less than that when the filling speed is 2 times the normal flow rate. In addition, at the initial stage of the low tundish level steel grade transition, the minimum amount of inclusions in the transition billet can be reduced to 40% of the average amount of inclusions in the old grade; however, the maximum number of inclusions in the transition billet increase by a factor of 2.5 times the average number of inclusions in the new grade at the end stage of the low tundish-level steel grade transition. It can be observed that the inclusions in the initial stage of the low tundish-level steel grade transition have less effect on the quality of the old grades; however, they have a greater effect on the new grades in the final stage of the low tundish-level steel grade transition.

Numerical Simulation of Residence Time Distribution (RTD) in Tundish with Channel Type Induction Heating

Numerical Investigation of Flow Characteristics of Molten Steel in the Tundish with Channel Induction Heating

Hydraulic and Numerical Simulation of Flow Field Characteristics in Induction Heating Continuous Casting Tundish

Molten Steel Flow, Heat Transfer and Inclusion Distribution in a Single-Strand Continuous Casting Tundish with Induction Heating

Numerical Simulation of Inclusion Collision Growth and Removal in a Tundish with Intermittent Induction Heating

The Removal of Inclusions with Different Diameters in Tundish by Channel Induction Heating: A Numerical Simulation Study

Magnetohydrodynamic flows and heat transfer in a twin-channel induction heating tundish

Simulation Study on the Influence of Different Molten Steel Temperatures on Inclusion Distribution under Dual-Channel Induction-Heating Conditions

Exploration of the Relationship between the Electromagnetic Field and the Hydrodynamic Phenomenon in a Channel Type Induction Heating Tundish Using a Validated Model

Numerical simulation on the multiphase flow and reoxidation of the molten steel in a two-strand tundish during ladle change

ESTABLISHMENT OF A FULL SCALE TUNDISH PHYSICAL SIMULATION PLATFORM AND APPLICATION RESEARCH

Numerical Simulation for the Improved 6 Strand Bloom Tundish of Baotou Steel

Analysis model of internal residence time distribution for fluid flow in a multi-strand continuous casting tundish

Numerical Investigation on Transient Flow and Inclusion Removal Behavior in Tundish During Ladle Change Process

Numerical Simulation of Transient Flow and Heat Transfer in a Steel Ladle During Holding Period

Numerical modeling of grade mixing and inclusion entrapment in eight strand billet tundish

Numerical Simulation of Steel Flow Through a One Strand Slab Tundish with Steel Flow Control Devices

Channel-Type Induction Heating Tundish Technology for Continuous Casting: A Review

Numerical Simulation on Refractory Wear and Inclusion Formation in Continuous Casting Tundish

Numerical Simulation of Fluid Flow and Heat Transfer in a Ductile Iron Ladle During Holding and Teeming

Study of Flow Characteristics of Tundish Based on Digital Image Velocimetry Technique