Abstract:Fiber Bragg Gratings (FBG) have great significance in the development of high-power fiber laser systems. Fabrication sources, fibers, and fabrication technology would affect the performance of FBGs directly. In this research, a scanning exposure method for fabricating FBGs in different types of photosensitive fibers with a 213nm solid-state laser source was proposed. The Q-switched Nd: YVO4 laser fifth harmonic source was compared with the traditional excimer lasers and the impacts of lengths, center wavelengths, titled angles, and apodization on the reflection and transmission spectra of FBGs were discussed. The scanning fabrication system, which can realize the tilting of phase mask and the adjustment and monitoring of tension, was built according to the characteristics that the output spot diameter of the fabrication source was sub-millimeter. While the high quality of fabrication was guaranteed, FBGs with lengths of 3mm~20mm, center wavelengths shift of 0nm~4.2nm, and tilted angles of 0~21 were obtained, and all the parameters were simultaneously adjusted and controlled, the deepest transmission loss of about -70dB. FBGs fabricated were of good stability and repeatability, especially in hydrogen fibers whose stability was independent of high-temperature annealing (1500C) which was different from the fabrication results of excimer laser sources. Then the unconformity between experimental results and theoretical simulation was discussed and the optimization schemes were proposed. The experimental results and analysis provided a better experimental scheme for UV laser fabricating FBGs and the experimental basis for further optimizing the fabrication technology and further analyzing the microscopic mechanism of optical fiber photosensitivity.

Temperature Control on Fiber Bragg Gratings to Suppress Spectral Broadening of 100-W Fiber Oscillator

Multifrequency Erbium-Doped Fiber Laser Operating at Room Temperature

Narrow Linewidth Fiber Laser Oscillator Based on Fiber Bragg Grating with High Power Spectral Density

Fiber Bragg gratings fabricated by femtosecond lasers for narrow-linewidth fiber laser

A Broad Continuous Temperature Tunable DBR Single-Frequency Fiber Laser at 1064 nm

Fabrication of fiber Bragg gratings with precisely adjustable and controllable parameters based on 213nm solid-state laser

Fiber Bragg grating sensing system for temperature measurements based on optically injected DFB-LD with an OEO loop

Temperature Stability of High Ge-doped Fibre Bragg Grating

SLM Fiber Laser Stabilized at High Temperature

A Wideband Frequency-Tunable Optoelectronic Oscillator Based on a Narrowband Phase-Shifted FBG and Wavelength Tuning of Laser

Narrow Line-Width Ytterbium-Doped Fiber Ring Laser Based on Saturated Absorber

Spectral power stabilization against temperature variations in multimode fiber Bragg gratings

2.19 kW narrow linewidth FBG-based MOPA configuration fiber laser.

Narrow linewidth erbium-doped fiber laser incorporating with photonic crystal fiber based Fabry–Pérot interferometer for temperature sensing applications

High-Spatial-Resolution High-Temperature Sensor Based on Ultra-Short Fiber Bragg Gratings With Dual-Wavelength Differential Detection

Sub-kHz Linewidth Fiber Laser via Weak Fiber Bragg Grating Enabled Self-Injection Locking

Spectrum Broadening Suppression for Kw-Class Narrow Linewidth FBG-based Fiber Laser

Fabrication of integrated single frequency DBR fiber laser directly on ytterbium doped fiber by femtosecond laser

Wavelength-switchable erbium-doped fiber laser incorporating fiber Bragg grating array fabricated by infrared femtosecond laser inscription

Investigation on temperature characteristics of weak fiber Bragg gratings in a wide range