Abstract:This paper adopts fractional‐order calculus and Laplace transform to model and analyze a ZCS boost converter with LC resonant tank, which mainly focuses on the influence of FO component on the soft switching characteristics, converter efficiency and output voltage gain of this isolated dc converter. The order of resonant inductor and capacitor will affect the amplitude/phase of resonant current, and then affect the converter ZCS characteristic. Based on the fractional‐order (FO) characteristics of inductors and capacitors, many basic PWM DC–DC converters are defined and modeled by FO calculus in previous studies, but the research of FO resonant dc converters is still in its early stage. Therefore, this paper adopts FO calculus and Laplace transform to model and analyze a ZCS boost converter with an LC resonant tank, which mainly focuses on the influence of the FO component on the soft switching characteristics, converter efficiency, and output voltage gain of this isolated dc converter. This paper extends the topology to the fractional order domain and conducts FO modeling. The order of the resonant inductor and capacitor will affect the amplitude/phase of the resonant current and then affect the converter ZCS characteristic. The analysis demonstrates that the reduction of FOI and FOC order is not conducive to the ZCS of switching devices and converter efficiency. Based on the voltage and current relationship of the FO LC resonant tank, a parameter design guideline is presented. Numerical tools are used to solve the FO output voltage gain and draw the gain curve. And the order of FOI and FOC provides new flexibility for the converter output gain and soft switching design. Finally, simulations and a 360 W hardware experimental prototype are conducted to verify the accuracy and effectiveness of theoretical analysis.

Design Method and Implementation of the Fractional‐order Inductor and Its Application in Series‐resonance Circuit

Passive Realization of the Fractional‐order Capacitor Based on Fractional‐order Inductor and Its Application

Numerical Analysis of a Fractional Nonlinear Oscillator with Coordinate-Dependent Mass

Generalized Fractional-order Electrical Element: Modeling, Response Characteristic Analysis and Circuit Simulation

Compact Fractional-Order Model of On-Chip Inductors with BCB on High Resistivity Silicon

Analysis and Modeling of Fractional Order LC Series Resonant Boost Converter Based on Fractional Calculus and Laplace Transform

ANALOG IMPLEMENTATION OF FRACTIONAL-ORDER ELECTRIC ELEMENTS USING CAPUTO-FABRIZIO AND ATANGANA-BALEANU DEFINITIONS

Development of an Inductor Design Tool Based on Multi-Objective Optimization and Finite Element Simulation

Implementation of a Fractional-Inductor (α<0.5) and its performance study in a high-frequency L α R integrator circuit

Principle, Frequency Characteristics, and Their Analysis

Complex Circuit Model for RF Inductors

Fractional-Order Modeling and Steady-State Analysis of Single-Phase Quasi-Z-Source Pulse Width Modulation Rectifier

The design and fabrication of LTCC chip inductors for high frequency applications based on barium ferrites

MODELING AND APPLICATIONS OF FRACTIONAL-ORDER MUTUAL INDUCTANCE BASED ON ATANGANA–BALEANU AND CAPUTO–FABRIZIO FRACTIONAL DERIVATIVES

Equivalent Circuit Analysis of an RF Integrated Inductor with Ferrite Thin-Film

On Systematic Design of Fractional-Order Element Series

Design and Simulation of Si-Based MEMS Inductor

Fractional-Order Modeling and Simulation of Magnetic Coupled Boost Converter in Continuous Conduction Mode.

Construction and Experimental Realization of the Fractional-Order Transformer by Oustaloup Rational Approximation Method

Modeling and Performance Improvement of Fractional-Order Band-Pass Filter Using Fractional Elements

A variable-order fractional proportional-integral controller and its application to a permanent magnet synchronous motor