Abstract:<p>The size, distribution and chemical composition of grain boundary η-phase precipitates (GBPs) and micro-segregation present in thick plate (140 mm) 7xxx Al alloys has been quantified across a range of length scales. To address the known limitations of individual characterisation methods, a number of cross-correlated, high resolution techniques have been used, including atom probe tomography (APT). A new-generation high-Zn alloy (AA7085) has been compared to a more established material, AA7050, in T7651 temper conditions. The results show that high angle grain boundaries in both alloys are dominated by quench-induced GBPs (Q-GBPs), covering up to ∼40% of the area in AA7050. When viewed on brittle intergranular fracture surfaces and in 3D, the Q-GBPs appear much larger than previously reported and exhibit complex branched-facetted morphologies. In AA7050, the Q-GBPs contain substantially higher levels of Cu (by 29 %) and Al (by 37%) and lower Zn (by 33 %) than AA7085. Classical modelling demonstrates that these differences result from different transformation pathways, with precipitates in the more quench sensitive AA7050 alloy nucleating at higher temperatures, which exaggerates the effect of alloy chemistry. In both alloys GB segregation was limited, with low levels of Zn detected relative to the matrix, but more Mg and less Cu in AA7050. It is, therefore, proposed that the higher Cu and Al, and lower Zn content, of the large Q-GBPs present in AA7050 is the main difference in GB microchemistry between the two materials and is the primary reason its GBs are less chemically active. The implications for the relative susceptibilities of the alloys to environmentally assisted cracking are briefly discussed.</p>

Structure of HCP/BBC Interphase Boundaries in AZ91 Mg-Al Alloy

Evolution of Precipitate and Precipitate/matrix Interface in Al-Zn-Mg-Cu(-Ag)alloys

Interfacial Segregation and Precipitates Behavior in the Ultrafine Grained Al-based Metal Matrix Composites

Disclosing Differential Precipitation Behavior of a Novel High Mg-containing Al-Mg-Zn-Si Alloy

Interface Structure Between Ag Precipitates and Cu Matrix and Its Effect on the Properties of the Cu-Ag Alloy

Enhancing Plasticity in BCC Mg-Li-Al Alloys Through Controlled Precipitation at Grain Boundaries

Intrinsic twin boundary of η-MgZn2 precipitates in the AA7050 aluminium alloy

Revisiting the precipitation mechanisms of Guinier-Preston zones, η′, and η precipitates in Al-Zn-Mg alloys

Structural and crystallographic characterization of grain boundaries coarse particles in an Al–Mg–Si alloy, using convergent beam electron diffraction

Crystal structure and stability of phases in Mg-Zn alloys: A comprehensive first-principles study

Electron Microscopic Study of Precipitate Free Zones along Grain Boundaries in the Mg96.9Gd2.8Nd0.3 Alloy

Characterization of precipitates in aged Mg-4 wt%Zn alloy

Experimental examination of strain field within GP zone in an Al–Zn–Mg–Cu alloy

On the formation of anti-phase boundaries and interphase boundaries in Al3Zr precipitates of Al-Cu-Zr alloy studied at atomic scale

Transmission Electron Microscopy Investigation and Interpretation of the Morphology and Interfacial Structure of the ∊′-Mg54ag17precipitates in an Mg–Sn–Mn–Ag–Zn Alloy

Multiscale analysis of grain boundary microstructure in high strength 7xxx Al alloys

Evolution of Deformation Substructure and MgxZnyCaz Metastable Phase in Fine-Grained Mg Alloys

High-throughput extraction of the anisotropic interdiffusion coefficients in hcp Mg-Al alloys

Formation mechanism of co-axial grain boundaries in a Mg alloy

Three-Dimensional Phase-Field Simulation and Experimental Validation of β-Mg17Al12 Phase Precipitation in Mg-Al-Based Alloys

Three-Dimensional Phase-Field Simulation and Experimental Validation of β -Mg 17 Al 12 Phase Precipitation in Mg-Al-Based Alloys