Abstract:Mg-7Gd-1Y-xNd-0.3Zr alloys (x = 0, 2, 4 wt%) were subjected to multidirectional forging (MDF) and aging treatment to prepare a fine-grained microstructure, and the influence of Nd addition on the microstructure and mechanical properties was investigated. Increasing the Nd addition leads to the refinement of the grains in the Mg-7Gd-1Y-xNd-0.3Zr alloys after MDF deformation, as well as a weakening of the intensity of the texture. Moreover, the addition of Nd caused a significant amount of Mg3RE phase to remain on the grain boundary after MDF deformation, and facilitated the precipitation of the Mg5RE phase on the grain boundary during aging treatment. Following peak aging, the β' phase is characterized by a typical chain-like distribution, which is induced by dislocation at early aging. The distribution of precipitation on the grain boundary acts to strengthen the boundary, while promoting the formation of precipitate-free zones (PFZs) after aging, which enhances ductility. With the increase in Nd content from 0 to 2 and then to 4 (wt%), the ultimate tensile strength (UTS) and yield strength (YS) of the studied alloys initially increased, reached a peak in the Mg-7Gd-1Y-2Nd-0.3Zr alloy, and then declined, while the elongation (EL) gradually decreased. The increase in strength is primarily attributed to precipitation and solid solution strengthening, while the decrease in elongation arises from the large quantity of precipitation resulting from the addition of Nd. The addition of 2Nd (wt%) to the Mg-7Gd-1Y-0.3Zr alloy increased the UTS and YS of the alloy by 34 and 37MPa, and the EL decreased from 12.4% to 7.0%.

Electron Microscopic Study of Precipitate Free Zones along Grain Boundaries in the Mg96.9Gd2.8Nd0.3 Alloy

A Detailed HAADF-STEM Study of Precipitate Evolution in Mg–Gd Alloy

Precipitation and its effect on the mechanical properties of a cast Mg–Gd–Nd–Zr alloy

Precipitation Microstructure and Age-Hardening Response of an Mg–Gd–Nd–Zn–Zr Alloy

Precipitation Behavior of Mg-7Gd-3Y-2Zn-0.5Zr Alloy during Isothermal Aging

Precipitate Evolution in Mg−7Gd−3Y−1Nd−1Zn−0.5Zr Alloy During Isothermal Ageing at 240 °C

Investigations on Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn-Zr-Nd Alloy

Precipitation Sequence of Η Phase along Low-Angle Grain Boundaries in Al-Zn-Mg-Cu Alloy During Artificial Aging

Co-precipitation on the Basal and Prismatic Planes in Mg–Gd–Ag–Zr Alloy Subjected to Over-Ageing

Atomic-scale Characterization of the Precipitates in a Mg-Gd-Y-Zn-Mn Alloy Using Scanning Transmission Electron Microscopy

Effect of Nd Addition on the Microstructure, Precipitate and Mechanical Properties of Mg-Gd-Y-(Nd) -Zr Alloys

Precipitation behaviors and mechanical properties of Mg-6Gd-Y-0.6Zr alloy

In Situ TEM Investigation of Electron Irradiation and Aging-Induced High-Density Nanoprecipitates in an Mg-10Gd-3Y-1Zn-0.5Zr Alloy

Atomic-scale Investigation of Precipitate Phases in QE22 Mg Alloy

Realizing the interaction mechanism of the solute grain boundary segregation and precipitation behavior of Mg-Zn-Gd-Sm alloy

Microstructure, mechanical properties and fracture behavior of peak-aged Mg34Y32Nd31Gd alloys under different aging conditions

Study on Microstructural Evolution and GP Zone Strengthening Mechanism by Solution and Aging Treatment in Non-dendritic Mg-6Zn-5Al Magnesium Alloy

Microstructure Evolution in the Fusion Zone of Laser-Welded Mg–Gd–Y–Zr Alloy During Solution and Aging Treatment

Precipitation in Mg–Nd–Y–Zr–Ca Alloy During Isothermal Aging: A Comprehensive Atomic‐Scaled Study by Means of HAADF‐STEM

Characterization and Strengthening Effect of Precipitate Microstructure in Mg-3nd-3gd-0.2zn-0.5zr Alloy Aged at 225 °C

Effect of Ca addition on microstructures of aged Mg-15Gd-0.5Zr alloy