Atomic structure of clusters and GP-zones in an Al-Mg-Si alloy

Calin D. Marioara,Sigmund J. Andersen,Christoph Hell,Jonas Frafjord,Jesper Friis,Ruben Bjørge,Inga G. Ringdalen,Olaf Engler,Randi Holmestad
DOI: https://doi.org/10.1016/j.actamat.2024.119811
IF: 9.4
2024-03-10
Acta Materialia
Abstract:The structures of atomic clusters and GP-zones preceding precipitation in an Al-0.70Mg-0.85Si-0.15Fe-0.25Mn (wt.%) alloy have been investigated by annular dark field scanning transmission electron microscopy imaging and density functional theory calculations. One analysed condition consisted of one-month natural aging, and another was in a pre-baked state after 24 h aging at 90°C. To quantify the effect of clusters and GP-zones on microstructure development during a subsequent isothermal artificial aging at 185°C, hardness evolution was measured, and precipitate statistics was performed at the peak hardness corresponding to 5 h aging. Several types of clusters and GP-zones have been observed and based on structure and visual appearance named 'Disordered Frank-Kasper', 'Square', 'Binocular', and 1β", 2β", 3β", 4β". The first four are most common in the natural aged condition and are associated with a well-known influence on the initial hardness evolution. The last three are fractions of the hardening β" phase and refer to the number of structural units they contain. These GP-zones have an increased density in the pre-baked condition, leading to a rapid increase in hardness during artificial aging and to a finer microstructure of high-density small needle precipitates at peak hardness.
materials science, multidisciplinary,metallurgy & metallurgical engineering
What problem does this paper attempt to address?