Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

A Power Dependent Frequency Selective Surface with Controlled Threshold Power

Power-Dependent Frequency-Selective Surface: Concept, Design, and Experiment

A Novel Dual-Band Frequency Selective Surface (FSS)

Multi-characteristic Integrated Ultra-wideband Frequency Selective Rasorber

A Novel Angularly Stable Wide Passband Frequency Selective Surface

Bandpass Frequency Selective Surface with Two Sharp Sidebands Based on Shunted Quarter‐mode Substrate Integrated Waveguide Cavities

Design of a Tapered Frequency Selective Surface for the Suppression of Edge Wave Scattering

A Bandpass Frequency Selective Surface With a Low Cross-Polarization Based on Cavities With a Hybrid Boundary

Design of a Broadband and Switchable Absorber Using an Absorb/Reflective FSS

Switchable Frequency Selective Surfaces Absorber/reflector for Wideband Applications

Filtenna-Filtenna Design for Broadband and High-Selectivity Frequency Selective Surface

A Novel Frequency Selective Surface with Smaller Size and Wide Band

A Broadband Tunable Frequency Selective Surface Absorber For Oblique Incidence Applications

A Novel Frequency Selective Surface Applied for EMI Suppression in Integrated Circuit Package

A Modified High-Selective Frequency Selective Surface Designed by Multilevel Green's Function Interpolation Method

A Tuneable Microwave Absorber Using AFSS

Design of a Dual-Band Electromagnetic Absorber with Frequency Selective Surfaces

Research Progress and Application Prospects of Active Frequency Selective Surfaces

A Trifunctional Active Frequency Selective Surface for 6G Shielding Applications

A broadband second-order bandpass frequency selective surface for microwave and millimeter wave application

A Wideband Transmission Frequency Selective Surface Rasorber