Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

Switchable Frequency Selective Surfaces Absorber/reflector for Wideband Applications

Design of a Broadband and Switchable Absorber Using an Absorb/Reflective FSS

Multi-characteristic Integrated Ultra-wideband Frequency Selective Rasorber

Temporally-controlled Switchable Microwave Rasorbers

A Novel Tunable Frequency Selective Surface Absorber with Dual-Dof for Broadband Applications.

Graphene-FSS Hybrid Absorptive Structure with Amplitude/Frequency Dual-Modulated Passband

Wideband Reconfigurable Reflectarray Based on Reflector-Backed Second-Order Bandpass Frequency Selective Surface

A Broadband Tunable Frequency Selective Surface Absorber For Oblique Incidence Applications

Four-Mode Switchable Frequency-Selective Surface Featuring Wide-Band and Angular Stability

Broadband Tunability of Polarization-Insensitive Absorber Based on Frequency Selective Surface

A Novel Angularly Stable Wide Passband Frequency Selective Surface

Design of a broadband multifunctional switchable absorber/reflector based on active frequency selective surfaces

Design of a Dual-Band Electromagnetic Absorber with Frequency Selective Surfaces

Design of a Wideband Absorption Frequency Selective Rasorber Based on Double Lossy Layers

A Wideband Transmission Frequency Selective Surface Rasorber

Multistate Active Control RCS Signature for the Continuous Adjustment Absorber/reflector Transformation Applications.

Design of Switchable Frequency-Selective Rasorber with A-R-A-T or A-T-A-R Operating Modes

A Bandpass Frequency Selective Surface With a Low Cross-Polarization Based on Cavities With a Hybrid Boundary

Ultrabroadband Double-Sided and Dual-Tuned Active Absorber for UHF Band

A Switchable Frequency Selective Rasorber with a Broad Transmission Window at the X-Band

Low-Profile FSS-Based Polarization-Insensitive Rasorber with Switchable Transmission Band