Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

Design of a Tapered Frequency Selective Surface for the Suppression of Edge Wave Scattering

Surface Impedance Modulation of FSS Composite Absorber for RCS Reduction at Normal and Grazing Incidence

Tapered Resistive Sheets Loading to the FSS Absorber for the Wide-Angle Monostatic RCS Reduction Applications

A Broadband Tunable Frequency Selective Surface Absorber For Oblique Incidence Applications

Design of a Dual-Band Electromagnetic Absorber with Frequency Selective Surfaces

Tapered Resistive Sheets and FSS Absorber Loading for the Wideband RCS Reduction of the Elliptic Surface at TM Polarization

A Wideband Transmission Frequency Selective Surface Rasorber

A Novel Frequency Selective Surface Applied for EMI Suppression in Integrated Circuit Package

Design of a Tunable Low-Frequency and Broadband Radar Absorber Based on Active Frequency Selective Surface

A Thin and Broadband Tunable Radar Absorber Using Active Frequency Selective Surface

A Novel Tunable Frequency Selective Surface Absorber with Dual-Dof for Broadband Applications.

A Novel Angularly Stable Wide Passband Frequency Selective Surface

Design of a Multilayered Frequency Selective Surface Absorber for the Suppression of Grating Lobes

Study on the Electromagnetic Properties of Frequency Selective Surface Absorber

A Wideband Transmission Frequency Selective Surface Rasorber with Low Insertion Loss

A Trifunctional Active Frequency Selective Surface for 6G Shielding Applications

Filtenna-Filtenna Design for Broadband and High-Selectivity Frequency Selective Surface

Design of a Wideband Absorption Frequency Selective Rasorber Based on Double Lossy Layers

Optically transparent and angularly stable broad‐stopband frequency selective surface for millimeter wave electromagnetic interference mitigation

Thin and Broadband Electromagnetic Absorber Design Using Resistors and Capacitors Loaded Frequency Selective Surface

Ultralow Scattering and Broadband Metasurface Using Phase Adjustable FSS Elements Embedded With Lumped Resistors