EXPERIMENTAL STUDY ON FLOW INSTABILITY OF NATURAL CIRCULATION IN A VERTICAL RECTANGULAR MINI-CHANNEL UNDER ROLLING MOTION

Zhiting Yu,Sichao Tan,Haibo Meng,Chong Chen,Yong Zhou

DOI: https://doi.org/10.1299/jsmeicone.2019.27.1732

2019-01-01

Abstract:An experimental work was performed to investigate the flow instabilities in a single rectangular mini-channel with deionized water as the working fluid. A DC power supply is used to gradually increase the heating power of the channel until the flow becomes unstable, while maintaining all other thermal parameters including pressure and the inlet temperature unchanged. In order to analyze the influence of rolling motion on two-phase flow instability, experiments under both static condition and rolling condition were conducted contrastively with the same thermodynamic parameters, such as the system pressure, inlet fluid temperature and heat flux applied to the test section. During the experiments, typical density wave oscillation (DWO) was observed in the static condition, and flow excursion also occurred when the heat flux reaches a relatively high value. However, single-phase flow fluctuation, trough-type flow oscillation, coupled flow oscillation and density wave oscillation were found in the rolling condition. Single-phase flow fluctuation, which fluctuates in sinusoidal wave, is directly induced by rolling motion, while trough-type flow oscillation is confirmed as the boiling incipience according to the relevant boiling curves. The coupled flow oscillation is supposed to be superposition of trough-type flow oscillation and DWO. Finally, pure density wave oscillation under rolling condition occurs when the inlet mass flux is reduced to a certain value. This is mainly the thermal hydraulic factors begin to play a dominant role compared with the additional forces induced by rolling motion. Besides, the influence of rolling motion on the onset of flow instability (OFI) and instability boundaries of natural circulation in a rectangular mini-channel was discussed.