Abstract:Saturated flow boiling experiments were conducted to investigate the influence of surface wettability on the hydraulic and thermal transport performance in a large width-to-height aspect ratio, one-sided heated rectangular microchannel with deionized water as the working fluid. The contact angles of the bare silicon wafer surface and superhydrophilic surface after deposited by a thin film of 100-nm-thickness silicon dioxide were 65 3 and less than 5 respectively, both of which were utilized as heated surfaces of the microchannel. Parametric experimental studies were carried out with the inlet vapor quality varied from 0.03 to 0.1 and the wall heat fluxes spanned from 4 W/cm(2) to 20 W/cm(2), at various mass fluxes ranging from 120 to 360 kg/m(2) s. High speed flow visualizations were conducted coupled with instrumental measurements to illustrate the effects of heat flux, mass flux and two phase inlet quality on the local heat transfer coefficient, averaged heat transfer performance, two phase flow structure and pressure drop characteristics for surfaces with distinct surface wettability characteristics in the microchannel. Experimental results showed that the local heat transfer coefficient decreased first until approaching a minimum value and then increased towards the exit along the flow direction. Severe heat transfer deterioration was obtained for the bared silicon wafer surface with increased inlet vapor quality and heat flux, resulting from the local dryout phenomenon as can be verified by the flow visualization. While the heat transfer performance of the superhydrophilic surface was relatively constant due to continuous and uniform distribution of the thin liquid film on the heated surface during annular flow dominance and subsequent delay to partial dryout occurrence, which outperformed the untreated hydrophilic surface without additional pressure drop penalty. (C) 2017 Elsevier Ltd. All rights reserved.

Effects of parameters on the two phase flow instability in a microchannel

EXPERIMENTAL INVESTIGATION AND FLOW VISUALIZATION OF THE TWO-PHASE FLOW INSTABILITY AT LOW VAPOR QUALITY IN A VERTICAL NARROW CHANNEL

Two-Phase Flow Instability of Boiling in A Double Microchannel System at High Heating Powers

Effect of Running Parameters on Flow Boiling Instabilities in Microchannels

Investigation of two phase flow instability in a narrow channel

Investigating Flow Instability Mode and Characteristics in a Microchannel Evaporator

Experimental Study of Flow Boiling Instabilities in Horizontal Tubes under Gas–liquid Stratification Condition: Effects of Heat Flux and Inlet Subcooling Degree

An Experimental Study of Flow Boiling Instability in a Single Microchannel

Boiling Instability in Parallel Silicon Microchannels at Different Heat Flux

Experimental Investigations on Flow Characteristics of Two Parallel Channels in A Forced Circulation Loop with Supercritical Water

Theoretical research on two-phase flow instability in parallel channels

Effects of Heat Flux, Mass Flux and Two-Phase Inlet Quality on Flow Boiling in a Vertical Superhydrophilic Microchannel

Unstable and stable flow boiling in parallel microchannels and in a single microchannel

Theoretical investigations on two-phase flow instability in parallel multichannel system

Non-Linear Analyses of Flow Boiling in Microchannels

LIQUID/TWO-PHASE/VAPOR ALTERNATING FLOW DURING BOILING IN MICROCHANNELS AT HIGH HEAT FLUX

Flow Patterns During Flow Boiling Instability in Silicon-Based Pin-Fin Microchannels

Theoretical Analysis and Modeling of Flow Instability in a Mini-Channel Evaporator

Thermal Relaxation and Critical Instability of Near-Critical Fluid Microchannel Flow.

Pressure Drop and Flow Boiling Instabilities in Silicon Microchannel Heat Sinks

Theoretical Investigations on Two-Phase Flow Instability in Parallel Channels under Axial Non-Uniform Heating