Abstract:In order to clarify the effect of particle coagulation on the heat transfer properties, the governing equations of nanofluid together with the equation for nanoparticles in the SiO2/water nanofluid flowing through a turbulent tube are solved numerically in the range of Reynolds number 3000 <= Re <= 16,000 and particle volume fraction 0.005 <= phi <= 0.04. Some results are validated by comparing with the experimental results. The effect of particle convection, diffusion, and coagulation on the pressure drop increment P, particle distribution, and heat transfer of nanofluid are analyzed. The main innovation is that it gives the effect of particle coagulation on the pressure drop, particle distribution, and heat transfer. The results showed that increment P increases with the increase in Re and phi. When inlet velocity is small, the increase in increment P caused by adding particles is relatively large, and increment P increases most obviously compared with the case of pure water when the inlet velocity is 0.589 m/s and phi is 0.004. Particle number concentration M-0 decreases along the flow direction, and M-0 near the wall is decreased to the original 2% and decreased by about 90% in the central area. M-0 increases with increasing Re but with decreasing phi, and basically presents a uniform distribution in the core area of the tube. The geometric mean diameter of particle GMD increases with increasing phi, but with decreasing Re. GMD is the minimum in the inlet area, and gradually increases along the flow direction. The geometric standard deviation of particle diameter GSD increases sharply at the inlet and decreases in the inlet area, remains almost unchanged in the whole tube, and finally decreases rapidly again at the outlet. The effects of Re and phi on the variation in GSD along the flow direction are insignificant. The values of convective heat transfer coefficient h and Nusselt number Nu are larger for nanofluids than that for pure water. h and Nu increase with the increase in Re and phi. Interestingly, the variation in phi from 0.005 to 0.04 has little effect on h and Nu.

Hydrodynamic Instability Of Nanofluids In A Channel Flow

Flow instability of nanofuilds in jet

A Review on the Flow Instability of Nanofluids

Hydrodynamic Instability of Fiber Suspensions in Channel Flows

Flow Boiling Heat Transfer and Two-Phase Flow Instability of Nanofluids in a Minichannel

Numerical Study of Instability of Nanofluids: the Coagulation Effect and Sedimentation Effect

Analysis of Error and Stability of Nanofluid over Horizontal Channel with Heat/Mass Transfer and Nonlinear Thermal Conductivity

Single phase nanofluids in fluid mechanics and their hydrodynamic linear stability analysis

Linear stability analysis of MHD mixed convection flow of a radiating nanofluid in porous channel in presence of viscous dissipation

Flow and Heat Transfer Characteristics of Nanofluids Containing Rod-Like Particles in a Turbulent Pipe Flow

Pressure Drop and Heat Transfer of Nanofluid in Turbulent Pipe Flow Considering Particle Coagulation and Breakage

Convective Heat Transfer and Resistance Characteristics of Nanofluids with Cylindrical Particles

Experimental study on instability of round nanofluid jets at low velocity

Linear temporal stability of Jeffery–Hamel flow of nanofluids

On the Non-Linear Instability of Fiber Suspensions in a Poiseuille Flow

Interface-resolved Numerical Simulations of Particle-Laden Turbulent Flows in a Vertical Channel Filled with Bingham Fluids

Thermal Instability of A Nonhomogeneous Power-Law Nanofluid in A Porous Layer with Horizontal Throughflow

Utilizing the Plateau-Rayleigh Instability with Heat-Driven Nano-Biosensing Systems

Experimental Research on the Hydrodynamic Instability of Fiber Suspensions in Channel Flow

Theeffectofnon-linearinteractionbetweengasandparticlevelocitiesonthe Hydrodynamicstabilityintheblasiusboundarylayer

Particle Distribution and Heat Transfer of SiO<sub>2</sub>/Water Nanofluid in the Turbulent Tube Flow