Abstract:Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, Ahead of Print. In a piping system, pipe bends are more flexible than straight pipes because of their curved geometry, supplemented by higher stress and strain concentration, leading to one of the crucial components in piping industries. Therefore, safe design of pipe bends is essential for smooth running of the piping system, and plastic collapse moment is one of its criteria. This paper utilizes three-dimensional finite element analyses to model empirical solutions for the plastic collapse moment for different angled pipe bends subjected to combined pressure and in-plane closing, in-plane opening, and out-of-plane bending moments. Plastic collapse moments for 30∘ to 180∘ pipe bends are determined for elastic perfectly plastic and strain hardening materials, employing large geometry change option and internal pressure effect. It is observed from results that pressure effect is more prominent in thinner pipe bends of larger bend angle under all bending cases. For in-plane opening and out-of-plane bending moments, collapse moment increases and then decreases with increase in pressure intensity for all sizes of pipe bend. However, for in-plane opening bending moment, collapse moments keep on decreasing for thicker ([math] = 11.33) pipe bends. Finally, the study presents new improved plastic collapse moment solutions for different angled pipe bends under bending moment and internal pressure, derived from the finite element results of elastic perfectly plastic and strain hardening material models.

J0301-1-2 Investigation for the Effects of Internal Pressure and Radius of Pipe on the Plastic Collapse Bending Stress

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Effect Of Pressure On Plastic Collapse Under The Combined Bending And Torsion Moments For Circumferentially Surface Flawed Pipes

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Plastic Collapse Stresses for Pipes with Inner and Outer Circumferential Cracks

Development of new improved plastic collapse moment equations of pressurized different angled pipe bends under bending moments

Plastic Collapse Stresses for Pipes With Circumferential Twin Flaws Using Combination Rules

PLASTIC COLLAPSE STRESSES FOR THICK WALL PIPES WITH EXTERNAL CRACKS

Empirical Correction Factor to Estimate the Plastic Collapse Bending Moment of Pipes with Circumferential Surface Flaw

Prediction Method For Plastic Collapse Of Pipes Subjected To Combined Bending And Torsion Moments

Prediction Method for Plastic Collapse of Circumferentially Cracked Pipes Subjected to Combined Bending and Torsion Moments

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

On the Collapse Failure of Dented Pipes under Bending Moment and External Pressure

Collapse Loads for Circumferentially Through-Wall Cracked Pipes Subjected to Combined Torsion and Bending Moments

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Failure Bending Stresses for Small Diameter Thick-Wall Pipes

Comparison of plastic collapse moment for different angled non-circular pipe bends under bending moments and internal pressure

Limit bending moment for pipes with two circumferential flaws under combined internal pressure and bending

Plastic Collapse Stresses Based on Flaw Combination Rules for Pipes Containing Two Circumferential Similar Flaws