Abstract:Purpose Composite cellular structures have wide application in advanced engineering fields due to their high specific stiffness and strength. As an emerging technology, continuous fiber-reinforced polymer additive manufacturing provides a cost-effective solution for fabricating composite cellular structures with complex designs. However, the corresponding path planning methods are case-specific and have not considered any manufacturing constraints. This study aims to develop a generally applicable path planning method to fill the above research gap. Design/methodology/approach This study proposes a path planning method based on the graph theory, yielding an infill toolpath with a minimum fiber cutting frequency, printing time and total turning angle. More specifically, the cellular structure design is converted to a graph first. Then, the graph is modified to search an Eulerian path by adding an optimal set of extra edges determined through the integer linear programming method. Finally, the toolpath with minimum total turning angle is obtained with a constrained Euler path search algorithm. Findings The effectiveness of the proposed method is validated through the fabrication of both periodic and nonperiodic composite cellular structures, i.e. triangular unit cell-based, Voronoi diagram-based and topology optimized structures. The proposed method provides the basis for manufacturing planar thin-walled cellular structures of continuous fiber-reinforced polymer (CFRP). Moreover, the proposed method shows a notable improvement compared with the existing method. The fiber cutting frequency, printing time and total turning angle have been reduced up to 88.7%, 52.6% and 65.5%, respectively. Originality/value A generally applicable path planning method is developed to generate continuous toolpaths for fabricating cellular structures in CFRP-additive manufacturing, which is an emerging technology. More importantly, manufacturing constraints such as fiber cutting frequency, printing time and total turning angle of fibers are considered within the process planning for the first time.

A Path Planning Algorithm of Closed Surface for Fiber Placement

Algorithms for Constructing Initial and Offset Path of Automated Fiber Placement for Complex Double-Curved Surfaces

Two-Stage Sector Partition Path Planning Method For Automated Fiber Placement On Complex Surfaces

An Improved Path Discretization Method for Automated Fiber Placement

Modeling and Process Planning for Curved Layer Fused Deposition

Path Planning Algorithm for Fiber Placement Based on Boundaries of Tow

Mechanism for Wrapping Fiber Around the Y Fork

An Optimization Approach for Path Planning of High-Quality and Uniform Additive Manufacturing

Adaptive Path Planning of Fiber Placement Based on Improved Method of Mesh Dynamic Representation

Path Planning and Optimization Algorithm for Fiber Placement of S-shaped Inlet

Research on fiber placement machine and path planning methodology

Path Planning Based on Ply Orientation Information for Automatic Fiber Placement on Mesh Surface

An Efficient and Adaptable Path Planning Algorithm for Automated Fiber Placement Based on Meshing and Multi Guidelines

Smooth Joint Motion Planning for Redundant Fiber Placement Manipulator Based on Improved RRT*

Variable-Angle Trajectory Planning Algorithm for Automated Fiber Placement of Two Non-developable Surfaces

As-built FE Thermal Analysis for Complex Curved Structures in Automated Fiber Placement

Variable-Angles Trajectory Planning Algorithm of Automated Fiber Placement for Conical Shell

Online Path Correction under End Point Nonholonomic Constraints – Implementation with Visual Sensing in Robotic Fiber Placement

Stress-Based Path Planning on Quad Mesh for Additive Manufacturing

Placement suitability analysis of automated fiber placement on curved surfaces considering the influence of prepreg tow, roller and AFP machine

A graph-based path planning method for additive manufacturing of continuous fiber-reinforced planar thin-walled cellular structures