Abstract:Automated fiber placement (AFP) is an advanced composite manufacturing technology which is widely used in the production of complex shaped aircraft components. However, on the surface with large curvature, the fiber compaction performance is poor, and the direction deviation and the geodesic curvature of the path increase sharply with the offset distance, resulting in various placement defects. To solve this problem, the influence of the surface curvature on the path performance is studied, and a two-stage sector partition path planning method for AFP on complex surface is proposed in this paper. The constraints of the direction deviation, turning radius and the compaction state of the fiber are comprehensively considered in this method. By analyzing the compaction feature, the distance between the roller and the surface is used to evaluate the compaction condition and an initial partition criterion is established according to the normal curvature of the surface along the roller axis. Then, the quantitative relationship between path performance and offset distance is derived, and the precise sector is determined under the constraints of placement direction and turning radius. The path performance constraints are fully considered in the path generation process, so the iterative process of evaluation-modification is effectively avoided. Simulations and experiments are then carried out on the winglet surface and the results show that compared with the parallel method, the proposed method can significantly improve the direction deviation, turning radius and compaction quality of the placement paths at the cost of gaps/overlaps. Satisfactory placement paths can be obtained with reasonable constraints on the complex surface. (C) 2020 Elsevier Ltd. All rights reserved.

Placement suitability analysis of automated fiber placement on curved surfaces considering the influence of prepreg tow, roller and AFP machine

Two-Stage Sector Partition Path Planning Method For Automated Fiber Placement On Complex Surfaces

An Analytical Model for Pressure Distribution in Automated Fiber Placement on Irregular Surfaces and Its Application in Aeronautical Manufacturing

As-built FE Thermal Analysis for Complex Curved Structures in Automated Fiber Placement

Modeling and experimental validation of compaction pressure distribution for automated fiber placement

An Improved Path Discretization Method for Automated Fiber Placement

Algorithms for Constructing Initial and Offset Path of Automated Fiber Placement for Complex Double-Curved Surfaces

Determination and application of posture adjustable domain under constraints of placement quality

Process-dependent Wrinkle Formation for Steered Tow During Automated Fiber Placement: Modeling and Experimental Verification

Automated Fiber Placement Path Planning and Analysis of Pressure Vessels

Analysis and Characterization of Interlaminar Tack for Different Prepreg Materials During Automated Fiber Placement

Compaction Pressure Distribution and Pressure Uniformity of Segmented Rollers for Automated Fiber Placement

Influences of Wrinkles Induced by Tows’ Offset in Automated Fiber Placement on the Bending Properties of Composites

Influence of Fiber Cutting at the Composite Grid Intersection on the Compressive Performance of Laminate

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Design and analysis of the mandrel structure for a composite S-shaped inlet

Smooth Joint Motion Planning for Redundant Fiber Placement Manipulator Based on Improved RRT*

Modeling of Tension Control System with Passive Dancer Roll for Automated Fiber Placement

Measurement, Identification, and Compensation of Pose Errors for Six-Axis Gantry Automated Fiber Placement Machine

Continuous Stiffness Optimization of Mobile Robot in Automated Fiber Placement

Modeling on the Effect of Automated Fiber Placement Induced Gaps in Curved Composite Laminates