Abstract:Since the logic 28 nm technology and beyond, ArF immersion lithography has been widely used in manufacturing. To fully utilize the potential of the lithographic resolution, process simulation has been used since the lithography process setup step. The accuracy of the model prediction can be a key factor in the process stability, defectivity, and yield of the final product. To get better model prediction, it is very important to develop a process model with as many parameters as possible with physical meanings. Since the analysis of exposure data with a physical model can provide insights into the process and the photoresist material, it may greatly accelerate the photoresist formulation development or improvement process. From another aspect, as the function of the photoresist is to record the aerial image information on wafer, theoretically, the photoresist image should not deviate much from the aerial image or it will inevitably reduce the information content of the aerial image, i.e., through various kinds of averaging, mixing, etc. Since the emergence of Optical Proximity Correction (OPC), the time that takes to finalize a photolithography process has been significantly lengthened and made more complicated. To make the OPC model more reliable and less dependent on patches, a more physical OPC model is necessary. Therefore, it is clear that if we can develop a photoresist formulation to realize a more physical photoresist image, or a photoresist image closer to the aerial image, we can greatly improve the photolithography process performance and the time consumed for the process setup including OPC. In this paper, we focus on several physical model parameters for photoresist, especially the effective photoacid diffusion length and photo decomposable base parameters. We will show that these two parameters can provide a good description of photoresist imaging behavior, and the resist formulation can be improved to match the physical model prediction with more accuracy.

Extraction of Exposure Modeling Parameters of Thick Resist

Simulation and Experimental Investigation of Immersion Flow Field in Immersion Lithography

Scratch-Concerned Yield Modeling for Ic Manufacturing Involved with A Chemical Mechanical Polishing Process

Physical model-based ArF photoresist formulation development

Dynamic Exposure Model of Scanning Beam Interference Lithography

A comparative study of resists and lithographic tools using the Lumped Parameter Model

PMMA resist profile and proximity effect dependence on the electron-beam lithography process parameters

Quantitative evaluation of residual resist in electron beam lithography based on scanning electron microscopy imaging and thresholding segmentation algorithm

Exposure Properties and Application of Acrylate-Based Dry Film Photoresists

Studies of energy dissipation distribution in low-energy electron beam lithography by Monte Carlo method

A Model for Dry Electron Beam Etching of Resist

Mathematical Modeling and Experimental Study on Photoresist Whirl-Coating in Convex-Surface Laser Lithography

Effects of Mold Geometries and Initial Resist Thickness on Filling Behavior in UV-Nanoimprint Lithography

Modeling and Optimization of Process Parameters of a DF-CCP Etcher Chamber

Investigation of Resist Filling Behavior in Microimprint Lithography by Computational Fluid Dynamics Simulation and Defocusing Digital Particle Image Velocimetry

Intensity Shift Correction for Thin Film Optical Parameter Determination

Photoresist Process Simulation to Study Line Edge Roughness

Simulation of Amine Concentration Dependence on Line Edge Roughness after Development in Electron Beam Lithography

Modeling and Simulation Development of Electron Beam Resist Based on Cellular Automata.

Research on Thermal Evolution of Polydimethylsiloxane Flexible Sample with a Practical 3-D Fib Power Deposition Model

An Investigation of the Backscattering Yield of Langmuir-Blodgett Resist Films in Electron-Beam Lithography