Abstract:Abstract During the exposure process of photolithography, wafer absorbs the exposure energy, which results in rising temperature and the phenomenon of thermal expansion. This phenomenon was often neglected due to its limited effect in the previous generation of process. However, in the new generation of process, it may very likely become a factor to be considered. In this paper, the finite element model for analyzing the transient behavior of the distribution of wafer temperature during exposure was established under the assumption that the wafer was clamped by a vacuum chuck without warpage. The model is capable of simulating the distribution of the wafer temperature under different exposure conditions. The flowchart of analysis begins with the simulation of transient behavior in a single exposure region to the variation of exposure energy, interval of exposure locations and interval of exposure time under continuous exposure to investigate the distribution of wafer temperature. The simulation results indicate that widening the interval of exposure locations has a greater impact in improving the distribution of wafer temperature than extending the interval of exposure time between neighboring image fields. Besides, as long as the distance between the field center locations of two neighboring exposure regions exceeds the straight distance equals to three image fields wide, the interacting thermal effect during wafer exposure can be ignored. The analysis flow proposed in this paper can serve as a supporting reference tool for engineers in planning exposure paths.

Studies of energy dissipation distribution in low-energy electron beam lithography by Monte Carlo method

Theoretical Study Of Low-Energy Electron Penetration In Resist-Substrate Target By Monte Carlo Simulation

An Investigation of the Backscattering Yield of Langmuir-Blodgett Resist Films in Electron-Beam Lithography

Superiority of Langmuir-Blodgett resist films in electron beam lithography as demonstrated by the backscattering yield

Quantitative evaluation of residual resist in electron beam lithography based on scanning electron microscopy imaging and thresholding segmentation algorithm

A comparative study of resists and lithographic tools using the Lumped Parameter Model

Modeling of heat transfer in target material during the electron beam evaporation process

Inverse Bremsstrahlung Absorption and the Evolution of Electron Distributions Accounting for Electron-Electron Collisions

Simulation Of The Velocity Distribution For Immersion Lithography

Multiscale Modeling of Electron Beam and Substrate Interaction: a New Heat Source Model

Simulation study of electron beam divergence and its distribution measurement

Reduction of the Effect of Electron Relaxation Behavior on the Femtosecond Laser-Induced Response of Copper Thin Film by Ballistic Energy Transfer

Numerical simulation of metal evaporation based on the kinetic model equation and the direct simulation Monte Carlo method

Optimization of Spatial Dose Distribution for Controlling Sidewall Shape in Electron-beam Lithography

Proximity Effect In Electron Beam Lithography

Exposure Dose Dependence on Line Edge Roughness of A Latent Image in Electron Beam/Extreme Ultraviolet Lithographies Studied by Monte Carlo Technique

Numerical study of the power deposition in low-pressure hollow cathode arc discharges

Local charging effect on metal surface induced by low energy focused electron beam

Study of temperature distributions in wafer exposure process

Monte Carlo simulation of Cu-resistivity

Quantum theory of electronic excitation and sputtering by transmission electron microscopy