Abstract:The harmonic method using a symmetric double probe was developed for measuring electron temperature and ion density (Meas. Sci. Technol. 23 085001). When an alternating voltage is applied to the symmetric double probe where the two areas of the collector for current collection are equal, the fundamental frequency current and third harmonic currents are generated. The electron temperature and ion density are obtained by measuring the fundamental frequency current and the third harmonic current. However, it is observed that the third harmonic current can rapidly decrease to the level of base noise when the ratio of the applied voltage to the electron temperature decreases. Therefore, it is necessary to increase the harmonic currents generated to improve measurement accuracy for electron temperature and ion density. In this paper, a harmonic method using an asymmetric double probe with different collection areas is proposed to measure electron temperature and ion density. By using the double probe with different collector area, the fundamental frequency current and the second harmonic current are generated. In the proposed method, the electron temperature and ion density are obtained by measuring the fundamental frequency current and the second harmonic current. It is found that the accuracy of the electron temperature can be improved by measuring the second harmonic rather than measuring the third harmonic current. For quantitative comparison, the electron temperature and ion density obtained by the proposed method were compared with the electron temperature and electron density obtained by the measurement electron energy probability function, which showed good agreement between them in argon plasma at various conditions. In addition, it was experimentally verified that the electron temperature can be accurately measured even when the chamber is electrically insulated, and a dielectric layer is deposited on the collectors of the double probe, such as in the plasma process.

Comparison of two electrostatic probes—single and asymmetrical triple probes

Divisionally Analytical Reconstruction of the Magnetic Field Around an Electromagnetic Velocity Probe

Analytical Calculation of the Measuring Error of an Electromagnetic Velocity Probe Caused by a Side Channel Wall

Divisionally Analytical Solutions of Laplace'S Equations for Dry Calibration of Electromagnetic Velocity Probes

Improved analysis techniques for cylindrical and spherical double probes

Comparative studies of cold/hot probe techniques for accurate plasma measurements

New Diagnostic Systems on HL-2A

A harmonic method for measuring electron temperature and ion density using an asymmetric double probe

Research on Low Pressure Electronic Density Diagnostic Method of Single Paperback Probe Based on Langmuir Probe Theory

G030083 Four-point Atomic Force Microscope Probe for Imaging the Electrica1 Characteristics of Materials

Measurement of plasma electron energy distribution functions by Langmuir probe using a modified AC modulation method

Usage of displaced current in Langmuir probe measurement

Electron density measurements in low-pressure plasmas using cutoff probes and comparison with hairpin and Langmuir probes

Effect of Electric Field on the Magnetic Probe

Comparative Analysis of Several Near-Field Probes for Magnetic Field Measurements

Langmuir probe diagnostic suite in the C-2 field-reversed configuration

Systematic Characterization of Dual Probes for Electromagnetic Near-Field Measurement

Characteristics of Langmuir Probe in Low Temperature, Weakly Magnetized Plasmas

An Efficient Probe Calibration Based Near-Field to Near-Field Transformation for EMI Diagnosis

Study of plasma parameters in high enthalpy ICP-heated wind tunnel by using single Langmuir probe

Microscopic Four-Point Atomic Force Microscope Probe Technique for Local Electrical Conductivity Measurement