Abstract:Alkyl-substituted dibenzothiophenes such as 4,6-dimethyldibenzothiophene are a kind of typical refractory sulfur compound in fuel oil. Herein, three-dimensional ordered macro–mesoporous (3DOM) tungsten oxide catalysts were successfully prepared for aerobic oxidative desulfurization of 4,6-dimethyldibenzothiophene. The experimental results indicated that the as-prepared material 3DOM WOx-400 not only contained a hexagonal packed nanoporous structure but also abundant oxygen defects on its skeleton, exhibiting aerobic oxidative desulfurization of over 99% in 4 h. Moreover, sulfur removal could still reach 99% after recycling five times. Through free radical capture experiments, the superoxide radical is reasonably proposed in the mechanism. This work would provide a feasible route to develop highly efficient nanoporous materials for desulfurization of fuels.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.0c02639?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.0c02639</a>.TGA profiles of the precursor with PMMA (A) and without PMMA (B) (Figure S1); FT-IR spectra of the precursor mixture at different calcination stages (Figure S2); SEM image of the PMMA sphere alloy as the template (Figure S3); macropore diameter distribution of 3DOM WOx-400 (Figure S4); Raman spectrum of commercial WO3 (Figure S5); XPS full-scan spectra of various samples (Figure S6); comparison on W 4f peaks of 3DOM WOx-400 and WOx-400 (Figure S7); W 4f core-level of 3DOM WOx-300 and 3DOM WOx-500 (Figure S8); EPR spectra of various samples (Figure S9); effect of the reaction temperature on sulfur removal in the desulfurization system (Figure S10); GC–MS analysis for the extractant of the catalyst phase after the reaction (Figure S11); SEM images of recycled 3DOM WOx-400 (Figure S12); FT-IR spectra of fresh and recycled 3DOM WOx-400 (Figure S13) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.0c02639/suppl_file/an0c02639_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Preparation of CuWO4 Foam and Its Use As a Heterogeneous Catalyst for Dimethyl Sulfoxide Oxidation in a Scale-Up Microreactor

Fabrication of Tungstate Metal Foams As Efficient Catalysts for Dimethyl Sulfoxide Oxidation in a Microreactor

Interface-Enhanced Oxygen Vacancies of CoCuOx Catalysts In Situ Grown on Monolithic Cu Foam for VOC Catalytic Oxidation

Development of Centrifugal Coating Device to Load CuZnZr/γ-Al2O3 Catalyst on Porous Substrates for Methanol Steam Reforming

Facile and Flexible Preparation of Highly Active CuCe Monolithic Catalysts for VOCs Combustion

Sintering- and oxidation-resistant ultrasmall Cu(I)/(II) oxides supported on defect-rich mesoporous alumina microspheres boosting catalytic ozonation

Highly Efficient Tungsten Trioxide Containing Mesocellular Silica Foam Catalyst in the O-heterocyclization of Cycloocta-1,5-diene with Aqueous H2O2

Synergistic Effects Between Copper and Tungsten on the Structural and Acidic Properties of CuOx/WOx–ZrO2 Catalyst

Uniform Si‐Infused UiO‐66 as a Robust Catalyst Host for Efficient CO2 Hydrogenation to Methanol

Copper-cobalt strong interaction to improve photothermocatalytic performance of cobalt-copper oxides supported on copper foam for toluene oxidation

Study of the preparation of CuWO4/C composite and it's application in oxidative desulfurization of model oil

In Situ Sulfation of Cu/TiO2 Catalysts for Catalytic Combustion of Dichloromethane

Liquid-phase preparation of CuO/ZrO2 catalyst used in slurry reactors and its catalytic activity for CO hydrogenation

The Green Preparation of Mesoporous WO3/SiO2 and Its Application in Oxidative Desulfurization

A novel UiO-66 encapsulated 12-silicotungstic acid catalyst for dimethyl ether synthesis from syngas

Cu/UiO-66: a novel nanocatalyst obtained by a microwave-assisted protocol in DMF-free media for the efficient phenol removal via catalytic wet peroxide oxidation

Preparation of Hollow Cu and CuO x Microspheres with a Hierarchical Structure for Heterogeneous Catalysis

Synthesis of a high surface area and highly dispersed Cu-O-Si complex oxide used for the low-temperature hydrogenation of dimethyl oxalate to ethylene glycol

Redox-Induced In Situ Growth of MnO2 with Rich Oxygen Vacancies over Monolithic Copper Foam for Boosting Toluene Combustion

Facile synthesis of homogeneous hollow microsphere Cu-Mn based catalysts for catalytic oxidation of toluene

Aerobic Oxidative Desulfurization by Nanoporous Tungsten Oxide with Oxygen Defects