Abstract:The high-precision metrological measurement of circular profile is crucial for various rotational parts, essential in precision machining, manufacturing, and assembly. The existing roundness error separation methods often suffer from harmonic suppression issues, limiting the range of separable harmonics and reducing accuracy. This article proposes a roundness error separation method based on time-frequency-domain transformation (TFDT) for parameter optimization to overcome these challenges. By establishing the relationship between separation accuracy and rotation angle error and optimizing parameters accordingly, the method balances error separation accuracy with the separable harmonic range. Theoretical simulations and experimental validations confirm the method's effectiveness. By comparing the separation results under different harmonic separation range requirements with those of the methods currently widely used in the field of roundness metrology, we have validated the effectiveness of this method in balancing separation range and accuracy. When the rotation angle is set to 1.406°, the harmonic suppression-free range expands from [0, 204] undulations per revolution (upr) to [0, 255] upr, representing an increase of approximately 25% compared to single-step rotation error separation technique (SEST). Compared to the SEST method, the deviation of this method from the multistep method is reduced by over 68%, and its standard deviation (STD) is only about 65% of that of the other two methods. This innovative approach provides comprehensive and accurate circular profile data, enabling high-precision roundness error separation across a broad harmonic range. It establishes a robust theoretical basis for advanced measurements in national metrology institutes and key laboratories.

Three-Probe Error Separation with Chromatic Confocal Sensors for Roundness Measurement

High precision roundness measurement with two chromatic confocal sensors

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

Research on Two Optical Methods for Aspheric Measurement

A Measurement and Separation Method for Perpendicular Errors of Rotary Axes

Optimal Measurement Angles of the Three-Probe Spindle Error Motion Separation Technique

Surface Bilateral Profile Measurement of Curved Transparent Components Based on Chromatic Confocal Sensor

Embedded displacement measuring device based on error separating technique of multi-circle overlapping three-probe method

Design of Roundness Measurement Model with Multi-Systematic Error for Cylindrical Components with Large Radius.

Bilateral form characterization of curved transparent components using chromatic confocal sensor

A High-Precision Roundness Error Separation Method Based on Time–Frequency-Domain Transformation for Parameter Optimization

Investigation of Error Separation for Three Dimensional Profile Rotary Measuring System

A Hybrid Three-Probe Method for Measuring the Roundness Error and the Spindle Error

Sest: A New Error Separation Technique for Ultra-High Precision Roundness Measurement

Implementation and Verification of a Dual-Probe Measurement System for Geometric Form Evaluation of a Ring-Type Cylinder

Dynamic Confocal Optical Probe Based on Time Difference Measurement

Study of Roundness Error Separation Based on Dynamic Measuring Model

Full Area Covered 3D Profile Measurement of Special-Shaped Optics Based on a New Prototype Non-Contact Profiler.

Accurate Inner Profile Measurement of a High Aspect Ratio Aspheric Workpiece Using a Two-Probe Measuring System