Abstract:This study focuses on the S-to-H2SO4 industry by investigating the chemical looping combustion (CLC) process utilizing Fe-based and Cu-based oxygen carriers (OCs), which are widely applied in CLC technology. The primary objective is to conduct combined CLC reactions of these two metal carriers in a three-zone temperature tube furnace, aiming to achieve a higher SO2 yield than what is attainable by reacting a single metal carrier with S. The investigation reveals promising industrial applications, offering potential benefits in terms of reducing equipment costs, enhancing energy efficiency, and lowering the emissions of the H2SO4 production industry. Through a series of experiments, the study examines the effects of reaction temperature and material molar ratios on SO2 generation. The solid reaction products were characterized using X-ray diffraction (XRD), scanning electron microscopy with energy-dispersive spectroscopy (SEM-EDS), and X-ray photoelectron spectroscopy (XPS). The experimental results indicate that the combined Cu-based and Fe-based OCs exhibit a higher SO2 yield during the reduction stage compared to using either Fe-based or Cu-based OCs independently. Under optimal conditions, with a carrier gas flow rate of 300 mL/min, an Fe2O3/S molar ratio of 6:1 in the second temperature zone, and a reaction temperature of 900 °C, the total SO2 yield in the third temperature zone reached approximately 85%. This was achieved at a reaction temperature of 850 °C, with an Fe2O3/S molar ratio of 6:1 in the first half of the zone and a CuO/S molar ratio of 12:1 in the second half of the zone. SEM-EDS analysis further revealed that the combined OCs showed no significant signs of agglomeration or sintering after 10 cycles of the reaction. However, Cu-based carrier particles increased in size by 50%, while Fe-based carrier particles remained relatively stable. Additionally, the low mass-to-atom ratio of S on the surface of OCs after the cyclic reaction suggests that the reduced-state OCs can be fully oxidized and regenerated following the release of SO2 during oxidation.

Chemical Looping Air Separation with Sr0.8Ca0.2Fe0.9Co0.1O3-δ Perovskite Sorbent: Packed Bed Modeling, Verification, and Optimization

Techno-economic analysis of chemical looping air separation using a perovskite oxide sorbent

Structural and Thermodynamic Assessment of Ba and Ba/Mg Substituted SrFeO3−δ for “Low-Temperature” Chemical Looping Air Separation

Energy, exergy, economic, environmental (4E) and dynamic analysis based global optimization of chemical looping air separation for oxygen and power co-production

Chemical Looping Combustion-Adsorption Of Hcl-Containing Syngas Using Alkaline-Earth Coated Iron Ore Composites For Simultaneous Purification And Combustion Enhancement

Pr doped CeO2 for chemical looping air separation at ultra-low temperatures

Plasma Chemical Looping: Unlocking High-Efficiency CO2 Conversion to Clean CO at Mild Temperatures

Development of a Steel-Slag-Based, Iron-Functionalized Sorbent for an Autothermal Carbon Dioxide Capture Process.

Kinetic and Thermodynamic Enhancement of Low-Temperature Oxygen Release from Strontium Ferrite Perovskites Modified with Ag and CeO2

Cu-Based Praseodymium-Modified γ-Al2O3 Oxygen Carrier for Chemical Looping Combustion Process Optimization

Chemical looping steam reforming of ethanol without and with in-situ CO2 capture

Red Mud-Based Perovskite Oxygen Carrier Preparation for Chemical Looping Gasification of Municipal Sludge.

Crystalline phase transformation of Sr-Fe based oxygen carriers modulate the cyclic performance for syngas and CO coproduction in chemical looping ethanol reforming coupled with CO 2 splitting

CO2 Capture and Desulfurization in Chemical Looping Combustion of Coal with a CaSO4 Oxygen Carrier

Design Theory of a CLC Air Reactor with Oxygen Carrier Recirculation and Its Application to a 3 MWth Pilot

Three-dimensional Simulation of a Gas-Fueled Chemical Looping Combustion System with Dual Circulating Fluidized Bed Reactors

Study on the Performance of the Purified CaSO4 Oxygen Carrier Derived from Wet Flue Gas Desulphurization Slag in Coal Chemical Looping Combustion

Optimizing S Chemical Looping Combustion with Cu-Fe Combined Oxygen Carriers: Performance and Mechanistic Insights

Chemical looping approaches to decarbonization via CO2 repurposing

Analysis of Thermally Coupled Chemical Looping Combustion-Based Power Plants with Carbon Capture

Co-production of syngas and H2 from chemical looping steam reforming of methane over anti-coking CeO2/La0.9Sr0.1Fe1−xNixO3 composite oxides