Abstract:Development of low-emission or zero-emission power generation systems is one of the most important subjects humanity is dealing with. Among different under development technologies and energy systems, a solid oxide fuel cell (SOFC) is an efficient and low-emission energy conversion device that is passing its research and development career. The current study aims to investigate a hydrocarbon fueled anode-supported planar-type SOFC due to simpler geometry, higher power density, and low overpotentials. In this study, electric performance of a SOFC with different interconnect designs under different operating conditions, such as operating voltage, channel inlet temperature, pre-reforming rate of methane, and inlet fuel and air velocity, has been investigated by use of a three-dimensional model considering complicated systems of equations: species mass conservation, first law of thermodynamics, conservation of momentum, and non-linear electrochemical models including multi-specious diffusion. It has been concluded that at a given voltage, inlet temperature, inlet air and fuel velocity, and pre-reforming rate, wider gas channels help to more uniform distribution and better penetration of reactant gases. Therefore, considering low-concentration polarization as an object, narrow ribs are preferred over wide ribs. By increasing the rate of the electrochemical reaction, the current and power density and subsequently the temperature difference increase but the fuel consumption in all cases has almost a decreasing trend. Also, it has been found that increasing inlet air velocity has little effect on current and power density but because of more cooling effect, it reduces the temperature difference and fuel consumption coefficient. On the other hand, increasing the inlet temperature has no meaningful effect on the temperature difference along the channels.

Numerical Simulation of an Internal Reforming Solid Oxide Fuel Cell Unit Fueled with Hydrogen-Natural Gas Mixtures

Influences of Hydrogen-Natural Gas Mixtures on The Performance of an Internal Reforming Solid Oxide Fuel Cell Unit: A Simulation Study

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

Numerical Simulation of a Direct Internal Reforming Solid Oxide Fuel Cell Using Computational Fluid Dynamics Method

Numerical study of thermoelectric characteristics of a planar solid oxide fuel cell with direct internal reforming of methane

Numerical Analysis of the Internal Fuel Processing in Solid Oxide Fuel Cells

Modeling Validation and Simulation of an Anode Supported Sofc Including Mass and Heat Transport, Fluid Flow and Chemical Reactions

Thermal Modeling and Management of Solid Oxide Fuel Cells Operating with Internally Reformed Methane

Numerical Study on the Thermal Characteristics in a Tubular Solid Oxide Fuel Cell with Indirect Internal Reformer

Numerical investigation of the chemical and electrochemical characteristics of planar solid oxide fuel cell with direct internal reforming

Simultaneous Characterizations of Segmented Electrochemical Characteristics and Temperature Distribution in the Hythane-Fueled Direct Internal Reforming Solid Oxide Fuel Cell

Simulation of a Flat-Tube Solid Oxide Fuel Cell with Symmetric Double-Sided Cathode Considering Different Fuel Compositions

Numerical Simulation of Tubular Solid Oxide Fuel Cells

Mathematical Modeling of Synthesis Gas Fueled Electrochemistry and Transport Including H2/CO Co-Oxidation and Surface Diffusion in Solid Oxide Fuel Cell

Modeling and Simulation of High Temperature Direct Internal Reforming Solid Oxide Fuel Cell

Two-dimensional Dynamic Simulation of a Direct Internal Reforming Solid Oxide Fuel Cell

Numerical Study on Effects of CH4–CO2 Internal Reforming on Electrochemical Performance and Carbon Deposition of Solid Oxide Fuel Cell

A comprehensive three-dimensional modeling of an internal reforming planar solid oxide fuel cell with different interconnect designs

Numerical Simulation for Anode-supported Intermediate Temperature Solid Oxide Fuel Cells

PERFORMANCE ANALYSIS FOR NATURAL GAS REFORMING SOFC/MGT HYBRID DISTRIBUTED ENERGY SYSTEM

Fine three-dimensional simulation of the heterogeneous anode of a solid oxide fuel cell with direct internal reforming