Sliding wear of medium-carbon bainitic/martensitic/austenitic steel treated by short-term low-temperature austempering
Quanshun Luo,Jianbin Li,Qintai Yan,Wenbo Li,Yubi Gao,Matthew Kitchen,Leon Bowen,Nicholas Farmilo,Yutian Ding
DOI: https://doi.org/10.1016/j.wear.2021.203732
IF: 4.695
2021-07-01
Wear
Abstract:<p>A medium-carbon Si-Mn-Ni-Cr-Mo alloyed (300M) steel was austempered for various short periods at its martensite-starting temperature of 285°C to seek improved sliding wear resistance as compared to the traditional martensitic and bainitic steels. Reciprocating sliding wear tests were performed against a WC/Co ball counterpart at a constant load of 50 N. The samples were characterised using field emission SEM, XRD and hardness testing. The associated wear mechanisms were analysed using SEM and cross-sectional TEM. The results revealed that a short austempering time of 6 minutes produced refined arrays of initial nano-bainitic ferrite laths and inter-lath filmy austenite and the majority martensite and retained austenite, while the majority of the microstructure remained martensitic with retained austenite. The hardness was unchanged to that of the as-quenched martensite of 6.4 GPa. Simultaneously the wear coefficient decreased by 41% from 2.67 to 1.58 × 10<sup>-15</sup> m<sup>3</sup>N<sup>-1</sup>m<sup>-1</sup>, which is also superior to both the tempered martensite at 1.65 × 10<sup>-15</sup> m<sup>3</sup>N<sup>-1</sup>m<sup>-1</sup> and the lower bainite at 1.87 × 10<sup>-15</sup> m<sup>3</sup>N<sup>-1</sup>m<sup>-1</sup>. Increasing the austempering time to 20 and 60 minutes resulted in wear coefficients of 1.38 and 2.18 × 10<sup>-15</sup> m<sup>3</sup>N<sup>-1</sup>m<sup>-1</sup>, respectively. The improved wear resistance has been explained by the wear induced microstructure evolution, especially the carbon partitioning induced stabilisation of retained austenite. The high-stress sliding wear was found to be dominated by severe shear deformation, which resulted in a nano-laminate structured top layer. Delamination wear was found to take place within the embrittled nano-laminates.</p>
engineering, mechanical,materials science, multidisciplinary