Abstract:The deformation behavior of a high-strength Mg-Al-Sn-Zn alloy under loading reversals has been thoroughly examined through a combination of experimental measurements and crystal plasticity modeling. We focused on an age-treated alloy fortified by distributed Mg2Sn particles and Mg17Al12 precipitates, which underwent two distinct loading cycles: tension-compression-tension (TCT) and compression-tension-compression (CTC), aligned with the extrusion direction (ED). The initial and deformed microstructures of the alloy were analyzed using the electron backscattering diffraction (EBSD) technique. Notably, the alloy displays tensile and compressive yield strengths (YS) of 215 MPa and 160 MPa, respectively, with pronounced anelastic behavior observed during unloading and reverse loading phases. Utilizing the elasto-viscoplastic self-consistent model incorporating a twinning–detwinning scheme (EVPSC-TDT), the cyclic stress–strain responses and resultant textures of the alloy were accurately captured. The predicted alternation between various slip and twinning modes during plastic deformation was used to interpret the observed behaviors. It was found that prismatic slip plays an important role during the plastic deformation of the studied alloy, and its relative activity in tensile loading processes accounts for up to ~66% and ~67% in the TCT and CTC cases, respectively. Moreover, it was discerned that detwinning and twinning behaviors are predominantly governed by stresses within the parent grain, and they can concurrently manifest during the reverse tensile loading phase in the TCT case. After cyclic deformation, the area fractions of residual twins were determined to be 7.51% and 0.93% in the TCT and CTC cases, respectively, which is a result of the varied twinning–detwinning behavior of the alloy in different loading paths.

Deformation dynamics and pre-compression effects on Mg-3Al-1Zn alloy: An in situ synchrotron-based multiscale study

Deformation Dynamics in Pre-Twinned Mg-3Al-1Zn Alloy: A Synchrotron X-ray Study

Onset of Detwinning in Mg-3Al-1Zn Alloy: A Synchrotron-Based X-ray Diffraction Study

Compressive Deformation Behavior of an Indirect-Extruded Mg-8Sn-1Al-1Zn Alloy

In Situ Monitoring of Dislocation, Twinning, and Detwinning Modes in an Extruded Magnesium Alloy under Cyclic Loading Conditions

Anisotropic Deformation of Extruded Magnesium Alloy AZ31 under Uniaxial Compression: A Study with Simultaneous in Situ Synchrotron X-Ray Imaging and Diffraction

Twin recrystallization mechanisms in a high strain rate compressed Mg-Zn alloy

Deformation behavior of Mg-8.5wt.%Al alloy under reverse loading investigated by in-situ neutron diffraction and elastic viscoplastic self-consistent modeling

In-situ SEM and EBSD Investigation of the Deformation Behavior of Extruded Mg-6Al-1Zn-1.1Sc Alloy

Effect of pre-deformation on the activation stress of {10–12} twinning in Mg–3Al–1Zn alloy

Twinning–Detwinning-Dominated Cyclic Deformation Behavior of a High-Strength Mg-Al-Sn-Zn Alloy during Loading Reversals: Experiment and Modeling

Characterization of dynamic microstructure evolution during hot deformation of Al–4.10Cu–1.42Mg–0.57Mn–0.12Zr alloy

Compressive stress and shear stress on the deformation mechanism of Mg-13Gd-4Y–2Zn-0.5Zr alloy at different deformation temperatures

Multiscale Measurements on Temperature-Dependent Deformation of A Textured Magnesium Alloy with Synchrotron X-Ray Imaging and Diffraction

Deformation Behaviour of Hot Extruded Mg Alloy Az31 During Compressive Deformation

Tension-compression Asymmetry of Extruded Mg-Gd-Y-Zr Alloy with a Bimodal Microstructure Studied by In-Situ Synchrotron Diffraction

Quasi-in Situ Electron Backscatter Diffraction Analysis of Twinning–detwinning Behavior in AZ31 Magnesium- Alloy Rolled Plates Subjected to Compression Loading in Different Directions

Revealing the Deformation Behavior and Resultant Texture Evolution in Extruded Dilute Mg–Bi–Sn–Ca Alloy During Hot Compression

Simultaneous Multiscale Measurements on Dynamic Deformation of a Magnesium Alloy with Synchrotron X-Ray Imaging and Diffraction

Investigation of the Microstructural Evolution of the As-Extruded Mg–6Zn–1Mn Alloy Sheets under High Strain Rate Tensile Loading

Simulation of Texture Evolution and Deformation Mechanism in Mg-3Al-1Zn Alloy During Uniaxial Compression