Abstract:At present, alloys are affected by various stress states during their deformation process. Various stresses can facilitate alloy deformation at the same time, and the influence of these stresses on material deformation is difficult to clarify. It is essential to clarify the difference in the deformation mechanism of an alloy in a single stress state In this work, the internal deformation mechanism of the Mg-13Gd-4Y-2Zn-0.5Zr alloy under two stress states at different deformation temperatures was studied by compression and torsion experiments. The results show that the grain is slightly deformed under shear stress deformation, and the long period stacking ordered (LPSO) phases of different forms show smaller kink angles, fewer kink times, and larger relative width ratios of the kink bands. Under compressive stress deformation, the grain is obviously compressed along the CD direction and presents a streamline, and the LPSO phase is severely kinked. Different stress states have a great influence on dislocation slip, and the shear stress state can easily provoke the initiation of non-basal slip. Non-basal slip has difficulty starting under compressive stress, which leads to dislocation packing. The dynamic recrystallization (DRX) fraction of compressive stress deformation is higher than that of shear stress deformation. Shear and compressive stress deformation alloys activate different kinds of twinning. In shear stress deformed alloys, tensile twins usually occur in grains with a small basal slip Schmid factor (SF). However, compression twins are activated in the compressive stress deformation alloy and occur in grains with larger SF values. When the slip is not fully coordinated with the deformation, kinking and twining occur to coordinate the deformation.

Compressive Deformation Behavior of an Indirect-Extruded Mg-8Sn-1Al-1Zn Alloy

Deformation Mechanism and Resultant Microstructural Characteristics in Extruded Dilute Mg-0.1Bi-0.1Sn Alloy with Bimodal-Sized Grain Structure under Compression

High Temperature Compressive Deformation Behavior of an Extruded Mg–8Gd–3Y–0.5Zr (wt.%) Alloy

Evolution of the Plastic Deformation Mechanisms in a Compressed Mg-10Gd-2Y-0.5Zr Alloy

In-situ SEM and EBSD Investigation of the Deformation Behavior of Extruded Mg-6Al-1Zn-1.1Sc Alloy

Revealing microstructures evolution and dynamic recrystallization mechanisms of Mg–Sn–Mn alloy during compressive deformation at elevated temperature

Microstructure Evolution and Texture Tailoring During Hot Compression at Low Temperatures of an Extruded Dilute Mg-0.5Sn-0.5Zn-0.5Al Alloy

Dynamic recrystallization mechanisms of as-forged Al–Zn–Mg-(Cu) aluminum alloy during hot comp.ression deformation

Revealing the Deformation Behavior and Resultant Texture Evolution in Extruded Dilute Mg–Bi–Sn–Ca Alloy During Hot Compression

Compressive stress and shear stress on the deformation mechanism of Mg-13Gd-4Y–2Zn-0.5Zr alloy at different deformation temperatures

Deformation dynamics and pre-compression effects on Mg-3Al-1Zn alloy: An in situ synchrotron-based multiscale study

Deformation Behaviour of Hot Extruded Mg Alloy Az31 During Compressive Deformation

Study on Thermal Compression Deformation Behavior and Constitutive Model of Homogenized Mg–5Zn–1Mn Alloy

Deformation Behavior and Dynamic Recrystallization of a Mg–Zn–Y–Zr Alloy

Hot Deformation Behavior and Workability Characteristic of a Fine-Grained Mg‒8Sn‒2Zn‒2Al Alloy with Processing Map

Hot Tensile Deformation Behavior and Microstructural Evolution of a Mg–9.3Li–1.79Al–1.61Zn Alloy

Deformation Behavior and Microstructural Evolution of Al-Zn-Cu-Mg-Sc-Zr Alloy During High Temperature Compression

Plastic deformation behaviors and microstructures of a wrought Mg-Zn-rare earth alloy

Deformation behavior of Mg-8Al magnesium alloy compressed at medium and high temperatures

Hot deformation behavior and resultant microstructural evolution of dilute Mg–Bi–Sn–Mn alloy during hot compression

Dynamic Compressive Behaviour and Microstructural Evolution of Extrusion-Shear Mg–6Zn–1Cu–1Y–0.6Zr Alloy