Abstract:Dry machining is being recognized as ecological machining due to its less environmental impact and manufacturing cost. However, the choice of dry machining is mainly influenced by the workpiece material properties, machining operation and cutting conditions. The recent emergence of austempered ductile iron (ADI) can be considered a significant economic advantage to the increasing industrial demand for cost- and weight-efficient materials. However, due to its microstructure-induced inherent properties, ADI is considered hard-to-machine material. Thus, the dry drilling of ADI is investigated in this paper. The ADI material used in the present study is produced using an innovative process route for near net shape casting production. Drilling experiments are conducted on a DMU80P Deckel Maho five-axis machining centre using PVD-coated carbide tools under dry cutting environment. The dry drilling of ADI under different cutting conditions is evaluated in terms of specific cutting force and tool wear analysis. The influence of cutting conditions on chip morphology and surface roughness is also investigated. The experimental results revealed that the combination of the low feed rate and higher cutting speed leads to the higher mechanical and thermal loads on the tool's cutting edge, resulting in higher specific cutting force values. This behaviour is further supported by the chip morphology analysis, which revealed the formation of segmented chips at higher cutting speed with segment spacing increase with an increase in feed rate. Depending upon the cutting parameters, different modes of tool failures including crater wear, flank wear, chipping, breakage and built-up edge were observed. Surface roughness analysis revealed the influence of tool wear and chip morphology on the machined surface finish.

Research On Wear Shape When Cutting Austempered Ductile Iron (Adi) With Pcbn Tools And Ceramic Tools

Research on Wear Behavior of Tools While Infeed Cutting Austempered Ductile Iron (ADI) with Ceramic Tools

Wear Behaviors of Pcd Tools in Turning Granite

Cutting performance and wear mechanisms of PVD coated carbide tools during dry drilling of newly produced ADI

Specific cutting force, tool wear and chip morphology characteristics during dry drilling of austempered ductile iron (ADI)

Study on cutting performance of double-inclined-wall cosine enhanced PCBN tool

Wear performance and mechanisms of PCBN tools in boring of powder metallurgy steels

STUDY ON THE WEAR PERFORMANCES OF CERAMIC TOOLS FOR MACHINING 304 STAINLESS STEEL

The Study on the Influence of Worn Tool Geometry on the Cutting Process of Ceramic Particle Reinforced Composites

Milling with ceramic inserts of austempered ductile iron (ADI): process conditions and performance

Cutting Performance and Wear/Damage Characteristics of PCBN Tool in Hard Milling

The Study on the Effect of Various Tool Wear Indicators on the Machining of MMCs

Research on Tool Wear in Machining of Particle Reinforced Aluminium Metal Matrix Composites Using PCD Tool

Experimental Investigation on the Machinability of PCBN Chamfered Tool in Dry Turning of Gray Cast Iron

Investigation on Cutting Performance of Micro-Textured Cutting Tools

Effect of PCBN tool grade and cutting type on hard turning of high-chromium white cast iron

Cutting Performance and Tool Wear of SiAlON and TiC-whisker-reinforced Si3N4 Ceramic Tools in Side Milling Inconel 718

Performance Assessment of Pcbn and Bcbn Tools in Machining of High-Chromium White Cast Iron

Experimental Study On Performance Of Cbn-Coated, Cbn-Uncoated And Pcd Tools In Turning Al 2124 Sic (45%Wt) Pmmc

Cutting performance and wear characteristics of Si3N4‐SiCw‐HfB2 ceramic cutting tools in turning of ductile cast iron

The Effect of Cutting Speed and Depth of Cut on Surface Roughness During Machining of Austempered Ductile Iron