Abstract:Next generation cosmic microwave background (CMB) polarimetry experiments aim to deploy order 500,000 detectors, requiring repeatable and reliable fabrication process with stable and uniform transition edge sensor (TES) bolometer performance. We present a hafnium (Hf)-based TES bolometer for CMB experiments. We employ a novel heated sputter deposition of the Hf films enabling us to finely tune the critical temperature (Tc) between 140 mK - 210 mK. We found elevated deposition temperatures result in films with lower stress, larger crystal sizes, and a smaller relative abundance of the m-plane to c-plane $\alpha$ phase, all contributing to the empirical linear dependence of critical temperature on deposition temperature. Crucially, the heated sputter deposition simultaneously ensures that the critical temperature does not drift despite exposure to heat throughout ongoing fab processes (sometimes reaching 350C) as long as the initial deposition temperature is not exceeded. Tcs lower than 170 mK require deposition temperature greater than 400C, far in excess of typical temperatures the wafer may experience. This ample thermal budget allows us to relax the stringent thermal management that conventional aluminum manganese (AlMn) TES bolometers require, for which temperatures as low as 200C - 250C are used to anneal the AlMn in an effort to adjust the Tc. Hf additionally exhibits an intrinsic steep superconducting transition (we measure $\alpha >$ 200) and a corresponding high loop gain (exceeding $\mathcal{L}>10$ deep in the transition). We precisely design the normal resistance of the TES to range between 10 milli-Ohm and 1 Ohm through an interdigitated geometry, making these TES bolometers compatible with both TDM, FDM, and $\mu$-mux readout systems. We report on bolometer parameters including critical temperature, normal resistance, saturation power, time constant, and loop gain.

Development of TES-based X-ray Microcalorimeters for HUBS

Low-temperature Characterization of Mo/Cu TES Devices for HUBS

Developing X-Ray Microcalorimeters Based on TiAu TES for HUBS

Development of Superconducting Microcalorimeters for the HUBS Mission

Irradiation of Mo–Cu Superconducting Bilayer Films with MeV Protons

Stable Temperature Regulation for TES Testing below 200mk Employing Improved Cohen-Coon Method

Preliminary Design of a 4-K Mechanical Cooling System for the HUBS Mission

Study on data processing for x-ray spectrometer based on microcalorimeter

Design and Development of a 224-pixel TES X-Ray Microcalorimeter System for Microanalysis with STEM

HUBS: Hot Universe Baryon Surveyor

Transition-Edge Sensor Microcalorimeters for X-ray Beamline Science

Absolute Energy Measurements with Superconducting Transition-Edge Sensors for Muonic X-ray Spectroscopy at 44 keV

Transition edge sensor based detector: from X-ray to $γ$-ray

Characterization of high aspect ratio TiAu TES X-ray microcalorimeters array using the X-IFU Frequency Domain Multiplexing readout

Development of the superconducting detectors and read-out for the X-IFU instrument on board of the X-ray observatory Athena

Design and characterization of a 90 GHz CMB TES bolometer

A Study of Mk Cooling System for Space Application

Development Of X-Ray Focusing Telescope For Hubs

Modelling a Transition-Edge Sensor X-ray Microcalorimeter Linear Array for Compton Profile Measurements and Energy Dispersive Diffraction

A Review of X-ray Microcalorimeters Based on Superconducting Transition Edge Sensors for Astrophysics and Particle Physics

Development of hafnium-based transition edge sensor bolometers for cosmic microwave background polarimetry experiments