Abstract:Direct Laser Writing (DLW) using ultrashort pulsed lasers and galvanometer scanning, has become an established process for surface texturing, allowing an extensive variety of feature geometries and texture designs to be produced. The minimum feature sizes that can be generated are however limited by factors such as the laser output power, beam diameter, beam wavelength and associated optics. To address the need to produce even smaller texture features, Direct Laser Interference Patterning (DLIP) has been developed, which utilises bespoke beam splitting and converging optics to produce periodic interference fringing and enabling surface textures in the micrometric size range to be produced. In this study, the texturing of cast iron cylinder liner segments using DLW and DLIP processes is explored, to assess their tribological performance in high efficiency internal combustion engines, such as for hybrid applications. To facilitate the designs of textures and to capture high resolution data on surface interactions at specific points in the combustion cycle, the segmentation of cylinder lines and piston rings is undertaken. The results of tribology tests covering combinations of high and low speeds and contact pressures, have shown that the mechanical honing of cylinder liners could potentially be replaced with the cleaner DLIP texturing as an alternative. Optimised texture designs using the DLW process achieved up to a 54 % reduction in kinematic friction between the piston ring and textured cylinder liner surfaces, compared with mechanically honed cylinder liner segments. These results have indicated that DLW texturing offers the best improvement in friction performance in the boundary and mixed lubrication regimes at higher contact pressures, at both lower and higher sliding speeds. The results also provide useful comparative data on the performance of meso and micrometric scale textures and how they can be best applied to cylinder liners.

Study on Tribological Properties of Laser-Textured Plunger in Methanol Engine

Adaptability of Laser Textured Liner to the Effects of Methanol Diluting Oil on Tribological Properties

Effect of Compound Texture on Lubrication and Sealing Performance of Plunger Pump

Influence of Microdimple on Lubrication Performance of Textured Plunger Pump

Experimental research on the frictional performance of real laser-textured cylinder liner under different lubrication conditions

Tribological behaviors of laser textured surface under different lubrication conditions for rotary compressor

Experimental Investigation on the Physical Properties and the High-Pressure Spray Characteristics of Lubricityimproved Methanol and Prediction of Spray Tip Penetration by Empirical Models

Experimental Research on the Wall-Wetting Effects on the Frictional Property of the Cylinder Liner–piston Ring Pair

Lubrication Adaptability to the Variations of Combustion Modes by Texturing Cylinder Liner in Engines

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Effects of different surface textures on tribological performances of the cylinder liner-piston ring: An experimental study

Influence of different loads and temperatures on solid lubricant-filled micro-dimples existing on both cylinder liner and piston ring

The friction of surface textured cylinder liner segments modified by Direct Laser Writing and Direct Laser Interference Patterning processes

Anti-Wear Property of Laser Textured 42CrMo Steel Surface

Tribological Performance of Three Advanced Piston Rings in the Presence of MoDTC-modified GF-3 Oils

An experimental study on tribological properties and air tightness of co-textured cylinder liner-piston ring on an engine tester

The Friction And Wear Behavior Of Laser Textured Surfaces In Non-Conformal Contact Under Starved Lubrication

Evaluation of tribological performance for laser textured surfaces with diverse wettabilities under water/oil lubrication environments

Process-surface morphology-tribological property relationships for H62 brass employing various manufacturing approaches

Molecular Dynamics Investigation on Micro-Friction Behavior of Cylinder Liner-Piston Ring Assembly

Study on the Tribological Properties of Multilayer Concentric Hexagonal Laser Texturing on Rubber Surfaces of Screw Pumps