Abstract:Abstract Abnormal discontinuous low-frequency noise occurs in the outdoor unit when the air conditioner is operating at 86~96 Hz. This noise has the characteristics of low frequency, strong penetration, long transmission distance, and poor sound quality, which can cause serious noise pollution. In order to reduce the low-frequency noise of the outdoor unit of the air conditioner, the discontinuous noise frequency is first located by testing the time-domain and frequency-domain maps of the noise. It is then compared with the frequency of fan rotation noise and structural radiation noise. It is found that the discontinuous noise is caused by the coupling of fan rotation noise and structural radiation noise. It is found that low-frequency noise improvement is significant when the frequency difference between two noise peaks is greater than 8 Hz or when a single noise peak is less than 25 dB(A) by studying the methods of frequency modulation and amplitude modulation of noise peaks. By adjusting the fan speed from 930 rpm to 940 rpm, the problem of 94 Hz noise is solved. Then, through testing the natural frequencies of the pipe and shell, it is found that the natural frequencies of the pipe are close to the excitation frequencies. The structural radiation noise is mainly caused by the pipe. Modal analysis is conducted on the pipe. When the normal boundary with the condenser and the normal boundary with the valve of the pipe is constrained by springs, the simulated values are closer to the measured values. Finally, structural optimization design is carried out on the pipe. When the U-tube of the exhaust pipe is shortened by 30 mm, a 30 g mass block is added to the cold inlet pipe, and a 97 g mass block is added to the lower part of the valve pipe of the suction pipe. The discontinuous noise of the optimized prototype is significantly improved.

Research on Refrigerant Flow Noise under Sudden Stop of Automobile Air Conditioning

Numerical Analysis and Structure Improvement of Automotive Exhaust Muffler's Acoustic Characteristics

Research on Two-stage Jet Refrigerant System with Water as Working Medium for Recycling Automotive Waste Heat

Numerical Analysis of Noise Radiation from Refrigerator Compressor Shell

Noise Analysis and Control of Reciprocating Refrigerators Compressor

Flow-induced Noise Mechanism and Optimization Design of Electronic Expansion Valve

Numerical and experimental investigation of cavitation characteristics of the electronic expansion valves

Numerical Simulation of Flow-Induced Noise in High Pressure Reducing Valve

Simulation and Design Improvement of a Low Noise Control Valve in Autonomous Underwater Vehicles

Numerical simulation and test validation for performance of a muffler in an exhaust pipe

Multi-objective optimization of muffler for vehicle air-conditioning compressor pipeline

Experimental Study on Noise Reduction Effect of a Muffler Inserted in Liquid Transporting Pipeline

Acoustic Performance of A Water Muffler

Simulation Study on Noise Reduction Effect of Porous Material on Electronic Expansion Valve

Low-Frequency Discontinuous Noise Diagnosis and Reduction of Air Conditioner Outdoor Unit

Numerical analysis of aerodynamic noise in a high parameter pressure reducing valve

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

Experimental Research on Acoustic Performance Optimization for Intake System

A Simulation Research on the Noise and Flow of Vehicle Cooling Fans

Prediction and optimization of aerodynamic noise in an automotive air conditioning centrifugal fan

Research on the Active Noise Control Technology for the Reduction of the Air Conditioner Noise in a Vehicle Cabin