Abstract:Abstract Plasma facing components are key to enduring high heat flux (HHF) loading from high-temperature plasma in nuclear fusion reactors. Understanding their thermal-mechanical behavior and cracking failure mechanisms related to structural designs and fabrication technologies during HHF loading is of great significance for improving their servicing performance and R&D (research and development) levels. In this study, a particular deep cracking failure process on the tungsten layer of a flat-type divertor mockup during 1800 cycles of 10 MW m −2 HHF loadings is completely monitored and measured with a special improved digital image correlation (DIC) technique. It is found that the DIC measurement under the HHF loading environment is improved successfully to capture fine deformation and strain fields with a spatial resolution less than 0.35 mm so that field strain on a 1 mm thick copper interlayer and deep crack initiation at several microns scale on the tungsten layer are measured out. Based on both full field and local strain and displacement measurements of the target divertor mockup, the thermal mechanical behaviors from deformation to crack initiation and propagation are successfully measured and traced. It is revealed that for the baseline copper interlayer design of a flat-type divertor mockup, the accumulation of plastic strain in the copper interlayer during ratcheting damage induces enough tensile stress on the tungsten layer during HHF cycles, leading to cracking and fracture failures even in its elastic state earlier than the copper LCF lifetime. Current Structural Design Criteria for ITER In-Vessel Components rules fail to cover this kind of ratcheting cracking failure mode in the design stage. New design models or mechanical validation rules to resolve this design blind spot should be established in the future.

Detection of Interlayer Delamination in W Monoblock of ITER Divertors Via Electromagnetic Acoustic Transduction

Detection of Debonding Damage of ITER Blanket Based on Acoustic Emission Method

Numerical Analyses of Electromagnetic Forces on the ITER Blanket Module Shield Block During Major Disruptions

Inspection of Delamination Defect in First Wall with a Flexible EMAT-scanning System

A Rotating Bias Magnetic Field EMAT and Applications to NDT of ITER Divertor Components

A Phased-Array Emat for Detection of Delamination Defect in A Tube of Multilayer Structure

Detection Mechanism of Delamination in Thermal Barrier Coatings of Turbine Blade Using a Rayleigh Wave EMAT

Numerical Simulation of EMAT Signals for Detection of Debonding in HIP Welding of Multilayer Tubes

Evaluation of electromagnetic forces on Chinese Dual Functional Lithium Lead Test Blanket Module in ITER

Inspection of Delamination Defect in First Wall Panel of Tokamak Device by Using Laser Infrared Thermography Technique

Nondestructive Testing of East W/Cu Divertor Components

Research on Nondestructive Examination of Bracket Welds of ITER In-Vessel Coils (IVC)

Numerical Simulation on the Eddy Current Electromagnetic Forces and the Mechanical Reliability of ITER In-Wall Shielding Blocks Induced by Plasma Disruption Events

Delamination Detection in Composite Plates Using Linear and Nonlinear Ultrasonic Guided Waves

Debonding Detection of Thin-Walled Adhesive Structure by Electromagnetic Acoustic Resonance Technology

Progress on the Ultrasonic Testing and Laser Thermography Techniques for NDT of Tokamak Plasma-Facing Components

Nondestructive testing of delaminated interfaces between two materials using electromagnetic interrogation

Lifetime measurement of a particular deep crack failure on a flat-type divertor mockup under cyclic high heat flux loading conditions

Numerical Study on Feasibility of ECT for Detection of Delamination Defect in HIP Welding of Multilayer Tubes

Detection of defects in ITER vacuum vessel based on the dynamic strain energy

Upgrade of Langmuir probe diagnostic in ITER-like tungsten mono-block divertor on experimental advanced superconducting tokamak.