Abstract:Given that two-phase closed thermosiphons (TPCT) are a prevalent and efficacious means of heat transfer. However, non-condensable gas (NCG) may potentially impact the heat transfer performance of the aforementioned devices. Nevertheless, the theoretical analysis of heat transfer in TPCT containing NCG is not fully comprehensive and therefore requires further supplementation by means of relevant experiments. This paper presents the development and experimental investigation of a theoretical heat transfer model for a TPCT containing NCG. The research encompasses the optimal fluid-filling ratio of R22 and R410a working fluid and the impact of NCG on heat transfer in the condenser section of TPCT. Experimental findings indicate that TPCT with R22 and R410a working fluids at a fluid-filling ratio of 60% and 50%, respectively, demonstrate excellent isotherm and heat transfer efficiency. The presence of NCG affects the condenser section heat transfer process of the vapor, leading to a 2 °C decrease in the average temperature of the condenser section of the TPCT (Tca). In comparison with the TPCT without NCG, it was observed that an increase in the mass of NCG from 0.0097 to 0.0197 mol resulted in a reduction in the effective length of the condenser section (La) and effective heat transfer rate (κ) of R22 TPCT. The decrease in La was 75.1 mm, while the decrease in κ was 15.02%. Furthermore, at the same NCG mass, the effective heat transfer rate of R410a TPCT is evidently superior to that of R22 TPCT. The NCG in the TPCT can be removed by using a check valve. Nevertheless, this will result in a reduction in the fluid-filling ratio of the TPCT. The temperature of the R410a TPCT containing 0.0197 mol NCG with a fluid-filling ratio of 50% is comparable to that observed in fluid-filling ratio of 40% after the NCG is exhausted.

Investigations on A Cryogenic Heat Transfer Unit Combining Natural Circulation Cooling and Two-Phase Closed Thermosyphon

Inverse heat transfer problem and its application in analyzing cryogenic treatment process

Experimental Investigation on High Performance Cryogenic Heat Transfer Based upon Natural Circulation Cooling

Theoretical and experimental investigation on heat transfer characteristics in a cryogenic two-phase closed thermosyphon

Natural circulation performance in a new cryogenic heat transfer unit

Simulation Test of Natural Circulation Precooling for Cryogenic Pump System

EXPERIMENTAL STUDY ON TWO TYPES OF TRANSCRITICAL CO2 HEAT PUMP WATER HEATER SYSTEM

Numerical Study on the Working Performance of a G-M Cryocooler with a Mechanically Driven Displacer

A NEW CRYOGENIC HEAT TRANSFER UNIT USED IN COOLING SUPERCONDUCTING MAGNET

Natural Circulation Precooling Experiment of Cryogenic Pump System

An Experimental Study Of Thermal Performance Of A Two-Phase Loop Thermosyphon (Tplt)-Based Steam Generator: Effects Of Thermal Boundary Conditions

Study on Cooling Capacity Characteristics of an Open-Cycle Joule-Thomson Cryocooler Working at Liquid Helium Temperature

Experimental Investigation on Heat Transfer in Two-Phase Closed Thermosyphon Containing Non-Condensable Gas

Experimental investigation on heat transfer performance of a cryogenic thermosyphon

Numerical investigation of transient phase-change transpiration cooling based on variable properties of coolant

Experimental investigation of CO2 thermosyphon flow and heat transfer in the supercritical region

Investigation on the effect of filling ratio on the steady-state heat transfer performance of a vertical two-phase closed thermosyphon

Numerical Investigation of the Two-Phase Closed Thermosyphon Operating with Non-Uniform Heat Flux Profiles

Thermodynamic Investigation on the Performance of Closed Wet Cooling Tower

Experimental and theoretical analysis of a closed loop two-phase thermosiphon under various states for latent heat storage

Thermal and Hydrodynamic Characteristics of Supercritical Co2 Natural Circulation in Closed Loops