Abstract:When a length is measured using a plane array device, reaching submicron-level accuracy is difficult because of the limitation imposed by the pixel size of the plane array device and subdivision technique. Therefore, we propose a method for measuring two-dimensional submicron displacements based on the multibcam interference principle of the Fabry-Perot (F-P) ctalon. A two-dimensional micro-displacement in the focal plane is obtained by calculating the variation of the center coordinate of a concentric interference ring. The virtual plane array pixel subdivision technique and peak-position coordinate local subdivision technology arc used to process the massive information of the plane array. In this way, the influence of undetermined systematic error is reduced, which allows an accurate calculation of the center coordinate of the concentric interference ring. The experiment uses an F-P ctalon with an interval of approximately 2 mm and a optical lens with focal length about 50 mm. The center of the imaging concentric interference ring is calculated at different positions in the focal plane. The results show that the measurement range can reach 3 mm. The experiment uses a laser phase-modulating homodyne interferometer for the comparison measurements. The results show that in the range of 31 pm., the linear fitting standard deviation of the measured results is 0.0151wil and the extended uncertainty is 0.036wil when the coverage factor is 2.15, where zoil is the relative pixel interval. These results confirm the accuracy of the measurement method.

Measuring Linewidth For Micro-Components Based On Regular-Reflective Triangulation Measuring Method

Small angle measurement method based on the total internal multi-reflection

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

Novel Enhancing Resolution Method for Measurement Straightness Error

Measuring Straightness Method with Common Path Compensation for Laser Drift

Distance Measuring Using Single-Point Laser Triangulation System Design Based on CMOS

Differential internal multi-reflection method for nano-displacement measurement

Experimental Study on the Measurement of Micro Structures

Method for Accurate Measurement of Micro-Nano Thin Film Device Resistivity

Width and Depth Gauging of Rectangular Subsurface Defects Based on All-Optical Laser-Ultrasonic Technology

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

Study of interferometric signal correction methods in ultra-precision displacement measurement

Micro-Raman measurement of thickness in microelectromechanical silicon structures

Laser Confocal Feedback Profilometry

Research of the Measuring Technology of Mems

A System for Measurement of Line Width by Combining Polarization Interferometry with Confocal Microscopy

Delay Error and Compensation in Measurement of Micro-Scale Using Aiming and Triggering Method

Method For Traceable Resolution Calibration Of The Laser Feedback Displacement Sensor

Stability research of laser confocal probe for measuring the micro-shpere

Submicron Displacement Measurement Method Based on Fabry-Perot Etalon

SABCMS, a new approach to higher lateral resolution of laser probe measurement system