Abstract:Storage tanks, silos and other welded cylindrical shell structures are usually constructed of rolled panels which are joined by patterned circumferential and longitudinal welds. Cold-formed residual stresses are produced during the cold bending process of steel panels, and obvious deformations and uneven distributed welding residual stresses are also produced because of the welding process. Studies have shown that residual stresses could weaken the critical buckling load of welded cylindrical shells under axial compression. Stress-relief post-weld heat treatment (PWHT) is a process that heats the workpiece gradually to 500∼650 °C, holding the temperature 0.5 hours then reducing the temperature slowly. Two cylindrical shell specimens are fabricated in this paper, and one is processed with stress-relief PWHT, while the other is not. The magnitude and distribution of residual stresses near the weld zone in each specimen are measured with an X-ray diffraction-based measurement system (named iXRD by the manufacturer), and initial imperfections and critical load of the specimens are obtained by the use of an axial buckling experiment platform. Thereafter, numerical simulations are conducted with measured geometric imperfections and residual stresses exerted into the finite element model. Finally, comparison of the critical loads of both cylindrical shell specimens is made, showing the effects of residual stresses on the plastic buckling of cylindrical shells under axial compression.

Study Of Thermal Stress Distribution On Thick Wall Cylinder By Thermal Shock Treatment

Calculation and Analysis of Piston Thermal Shock by Using Plate Model

Effect of Post-Weld Heat Treatment on the Plastic Buckling of Welded Cylindrical Shells

Thermal shock investigation on solid cylinders subjected to rapid energy deposition

Strength and Fatigue Analysis of Tube-Sheet Subjected to Thermal Shock

An analytical method for thermal stresses of a functionally graded material cylindrical shell under a thermal shock

Transient Thermal Stress Analysis for a Circumferentially Cracked Hollow Cylinder Based on Memory-Dependent Heat Conduction Model

Fracture Behavior and Thermal Shock Resistance Analysis of Thermoelectric Material Plates and Shells under Thermal and Electric Shocks

Thermal Stress Considered in Design of Jacketed Vessel

TEMPERATURE FIELD AND THERMAL STRESS FINITE ELEMENT ANALYSIS OF A 50MW STEAM TURBINE'S CYLINDER IN A POWER PLANT

Stress Analysis of Ellipsoidal Head with Heating Spiral

An Analytical Method for the Thermo-Mechanics Coupling Study of Thin-Walled Spherical Shell Structure

DQM-Based Thermal Stresses Analysis of a Functionally Graded Cylindrical Shell Under Thermal Shock

A Generalized Thermal Deviation Factor to Evaluate the Comprehensive Stress of Tubes under Non-Uniform Heating

Experimental and numerical study of circular, stainless thin tube energy absorber under axial impact by a control rod

THERMAL STRESS ANALYSIS AND OPTIMIZATION OF SUBSTRATE/COATING STRUCTURE UNDER THERMAL SHOCK

Experimental and Numerical Analysis for the Dry Patch and Thermal Stress of One Heating Surface

Finite Element Analysis of Thermal-Mechanical Behavior in the Thermal Barrier Coatings with Cooling Hole Structure

Thermal Shock Resistance of Solids Associated with Hyperbolic Heat Conduction Theory

Shakedown Analysis and Experimental Study of Thermal Barrier Coatings

Thermal shock fracture in a cracked strip: Incorporating convective heat transfer between lateral surfaces and ambient environment