Abstract:The development of sensitive fiber-optic accelerometers is a subject of continuing interest. To acquire high resolution, Michelson phase interferometric techniques are widely adopted. Among the variety structures, the compliant cylinder approach is particularly attractive due to its high sensitivity that is defined as the induced phase shift per applied acceleration. While the two arms of Michelson interferometer should be at the same optical path, it is inconvenient to adjust the two arms' length to equal, also the polarization instability and phase random drift will cause a signal decline. To overcome these limitations, a novel optical fiber accelerometer based on differential interferometric techniques is proposed and investigated. The interferometer is a Sagnac-like white light interferometer, which means the bandwidth of laser spectrum can be as wide as tens nanometers. This interferometer was firstly reported by Levin in 1990s. Lights are divided to two paths before entering the coupler. To induce time difference, one passes through a delay arm and another goes a direct arm. After modulated by the sensing component, they reflect to opposite arm. The sensing part is formed by a seismic mass that is held to only one compliant cylinder, where the single-mode optical fiber is wrapped tightly. When sticking to vibrations, the cylinder compresses or stretches as a spring. The corresponding changes in cylinder circumference lead to strain in the sensing fibers, which is detected as an optical phase shift by the interferometer. The lights from two arms reach the vibration source at different time, sensing a different accelerate speed; produce a different optic path difference. Integrating the dissimilarity of the accelerated speed by time can obtain the total acceleration graph. A shaker's vibration has been tested by the proposed accelerometer referring to a standard piezoelectric accelerometer. A 99.8% linearity of the optical phase shift to the ground acceleration is achieved. The acceleration sensitivity is 300 rad/g. It proves to have a simple structure, good practice, reliable measurement and stable performance.

Current Developments And Prospects Of Novel Fiber Optic Accelerometers

The New Demodulate Technology of Fiber Optics Gyroscope

Research On Accelerometer Based On Multi-Mode Interference

A Novel Differential Optical Fiber Accelerometer

Development And Applications of Fiber Bragg Grating Accelerometers

Study on Miniature Fiber Optic Accelerometer System

Design, Simulation and Optimisation of a Fibre-optic 3D Accelerometer

A Novel Current Sensor System Utilizing FBG F- P Interferometer

Recent Progress of All-Fiber Optic Current Sensors

A Novel Fiber Bragg Grating Accelerometer

A New Fiber Optic Accelerometer Based on Fiber Bragg Grating

Compact Fiber Optic Accelerometer

Fiber Fabry-Perot accelerometer with extended dynamic range and low noise floor

Recent Advancements in Resonant Fiber Optic Gyro—A Review

Sensitivity Enhancement Method for Dual-Polarization Interferometric Fiber-Optic Angular Accelerometer

Recent Progress Of Optical Fiber Fabry-Perot Sensors

Miniature Tri-Axis Accelerometer Based on Fiber Optic Fabry-Pérot Interferometer.

Theoretical Model and Design of Highly Sensitive Reflective Fiber Optic Fabry-Pérot Cavity Accelerometer Independent of Fiber Stiffness

A Novel Demodulation Method For The Sagnac Interferometric Fiber Current Sensor

Ultra-high-resolution phase demodulation based miniature fiber-optic accelerometer at low and medium frequencies

Low-Frequency High-Resolution Fiber Fabry-Perot Interferometric Accelerometer Based on Double-Spring-Supported Oscillator