Abstract:Phase sensitive optical time domain reflectometry (Φ-OTDR) has been widely used in many applications for its distributed sensing ability on weak disturbance all along the sensing fiber. However, traditional Φ-OTDR cannot make quantitative measurement on the external disturbance due to the randomly distributed position and reflectivity of scatters within the optical fiber. Recently, some methods have been proposed to realize quantitative measurement of dynamic strain. In these literatures, the fiber with or without FBGs in practice was easily damaged and with difficulty of maintenance. PZT is employed to generate strain event in the fiber. There is a large gap compared with the real detecting environment, which will not reveal the full performance of the sensing system. In this paper, a distributed optical fiber sensing (DOFS) system for dynamic strain measurement based on artificial reflector is proposed and demonstrated experimentally. The fiber under test (FUT) is composed by four 20-meter long single mode optical fiber patch cords (OFPCs), which are cascaded with ferrule contactor/physical contact (FC/PC) connectors via fiber flanges. The fiber facet of FC/PC connector forms an artificial reflector. When the interval between the two reflectors is changed, the phase of the interference signal will also be changed. A symmetric 3×3 coupler with table-look-up scheme is introduced to discriminate the phase change through interference intensity. In our experiment, the center 10m section of the second OFPC is attached to the bottom of an aluminum alloy plate. An ordinary loudspeaker box was located on the top of the aluminum alloy plate. The dynamic strain generated by the loudspeaker box is transmitted from the aluminum alloy plate to the OFPC. Experimental results show that the proposed method has a good frequency response characteristic up to 3.2 kHz and a linear intensity response of R2=0.9986 while the optical probe pulse width and repetition rate were 100ns and 10 kHz respectively. Meanwhile, triangle and cosine amplitude-modulated (AM) dynamic strain applied on the fiber are successfully discriminated. The artificial reflectors based on FC/PCs were easily assembled and maintained, and the method of vibration transmission closely resembled the real circumstance than PZT. Therefore, these advantages will extend the potential of this Φ-OTDR technology in structure health monitoring.

Measurement and analysis about the strain of fiber opitical loop

Analysis on the Temperature Fluctuating of FOG′s Source

The New Demodulate Technology of Fiber Optics Gyroscope

General comments on signal processing scheme for fiber optic gyroscope

Principle and Application of High Dynamic Fiber Gyroscope

Study of Wavelength Temperature Stability of Multifunctional Integrated Optical Chips Applied on Fiber Optic Gyroscopes

Compensation of Fiber Optic Gyroscope Vibration Error Based on VMD and FPA-WT

Digital System Study Applied to Performance Detection of Optic Fiber Gyroscope

Design and realization for FOG pure lag test system

Theory And Error Compensation Method Based On The Tilt Sensor Adopted In Dynamic Angle Measurement Of The Fiber Optic Gyroscope

Uncertainty Analysis of Dynamic Goniometer Based on Fiber Optic Gyroscope

The stability of optical fiber as strain sensor under invariable stress

Thermal Strain in Lightweight Composite Fiber-Optic Gyroscope for Space Application

Advanced Fiber Optic Sensing for Cryogenic Simultaneous Temperature and Strain Measurement

Strain Transfer Mechanism in Surface-Bonded Distributed Fiber Optic Sensors under Different Strain Fields

Experimental analysis of fiber-optic displacement sensors

Strain Measurement Technology and Precision Calibration Experiment Based on Flexible Sensing Fiber

Modified Dynamic North-Finding Scheme With a Fiber Optic Gyroscope

Characteristics Analysis of the Fiber Optic Gyroscope with Double Fiber Ring Resonators

Improved Φ-OTDR Sensing System for High-Precision Dynamic Strain Measurement Based on Ultra-Weak Fiber Bragg Grating Array

A Distributed Optical Fiber Sensing System for Dynamic Strain Measurement Based on Artificial Reflector