Abstract:A surface strain measurement system (XJTUSM) for sheet metal forming is developed based on close range industry photogrammetry. A circular grid pattern is electrochemically etched onto the surface of flat sheet metal before forming. As the sheet metal is pressed into a desired shape, these circular grid nodes are deformed into approximate elliptical shapes. Original images are then recorded from different photo stations using a single camera. The three-dimensional (3D) coordinates of these ellipse centers are reconstructed according to image processing technologies, which include noise reduction, adaptive thresholding, sub-pixel edge detection, least-square ellipse fitting, camera calibration, fast matching and reconstruction of grid nodes. Subsequently, a 3D grid generation procedure is performed to build the topology of separate grid nodes and the deformation gradient tensor is calculated. Finally, the surface strains are derived from the deformation gradient tensor and the forming limit diagram (FLD) is thus obtained. To evaluate the accuracy of the novel system, a tensile experiment was carried out, and the high-accuracy surface strain measurement system XJTUDIC was employed for comparison. The surface strains measured by two systems agree well. The XJTUSM system can be used to diagnose production problems, identify critical areas and/or verify the accuracy of numerical modeling.

A Three Dimensional Profiler For Cold Rolled Steel - Sheet Surface

MULTI-CHANNEL WIDTH MEASURING INSTRUMENT WITH CCD FOR COLD ROLLED SHEETS

Three-Dimensional Measurement System for Inner Surface of Long Tubular Parts Based on White Light Interference

Surface Form Measurement of a Small Roll Workpiece

Non-Contact High-Precision Surface Three Dimensional Profiler

Single-Shot White-Light Dispersive Interferometric Profilometer

Surface 3D profiler based on scanning white light interferometry method

Two-Dimensional Structural Surface Measurement Based On Spectrally Resolved White-Light Interferometry

An Analysis of the Three-Dimensional Surface Topography of Textured Cold-Rolled Steel Sheets

Research on Two Optical Methods for Aspheric Measurement

Surface 3D Topography Measurement of Roller

Research on three-dimensional profiler for super-smooth surface

New 3D surface profile measurement based on phase-shift interfering technology

Study on the on-line measurement system for the section dimensions of hot-rolled shaped steel

Full Area Covered 3D Profile Measurement of Special-Shaped Optics Based on a New Prototype Non-Contact Profiler.

A dual-probe three-dimensional profile measurement system

Research on 3D-full field strain fast measurement system in the process of sheet metal forming based on photogrammetry

A Structured Light Vision Sensor for Online Measurement of Steel-Plate Width

Surface Bilateral Profile Measurement of Curved Transparent Components Based on Chromatic Confocal Sensor

Measuring the 3D shape of high temperature objects using blue sinusoidal structured light

Circular Grid Pattern Based Surface Strain Measurement System for Sheet Metal Forming