Measurement of deformed surface and key data processing based on reverse engineering

Yongjian Zhu,Jingxin Na,Shijie Wei

DOI: https://doi.org/10.1007/978-1-4614-7010-6_81

2013-01-01

Abstract:After the metal sheet forming, the strain change should be known through some ways in order to conduct the stress analysis of forming process. To achieve this goal, some special circle marks are imprinted on the sheet surface, and after forming, the deformed circle marks should be measured. The previous method uses a Vernier Caliper to manually measure the stretched rope, which is highly laborious and inaccurate. To overcome this disadvantage, a non-contacting method is adopted to achieve all the coordinates' data based on the structure-light principle. Then the achieved coordinates' data of spatial surface are fitted to be a CAD model through reverse engineering (RE). In RE, the CAD surface is unfolded to be a plane or two orthogonal lines are projected on the CAD surface, so the deformed circle marks - spatial ellipses could be measured in size completely at one time. The experiments prove that the measured accuracy is about 0.01 mm, higher than the previous manual one. © 2013 Springer Science+Business Media New York.