Study on Edge Detection Based on Sampling in CNC Non-Contact Measuring System
Wang, Wen,Lu, Keqing,Chen, Zichen
DOI: https://doi.org/10.1049/cp:20060925
2006-01-01
Abstract:Along with the rapid development of aerospace, automobile, die & mold industries, free-form surface products are widely used, and the measurement and reverse engineering of freeform surface products become research focus. Free-form surface products include many kinds of curve patches (flat, column surface, spherical surface, irregular surfaces, etc). The key in reverse engineering of free-form surface products is numerical measurement. Between the product surfaces and measuring platform is the skip edge, and C0&C1 continual edges are between the patches. Measuring by different areas compartmentalized according to the edges is a good method, which expedites the measurement and modeling. Even in whole measurement, the ship edge and C0&C1 continual edge are also important in surface modeling. In recent years, CCD camera or data point segmentation from massive data point clouds is often applied in edge detection research. But some negative factors still exist when using the CCD to integrate CNC machine such as difficult assembly, complicated system demarcation and high cost and so on. The disadvantages of using data point segmentation are low precision, lots of useless data points and measurement time, reduce the efficiency. In order to overcome the disadvantages, this article aims at laser non-contact measurement, an edge measuring method of free-form surface which is based of sampling is put forward. And it provides an idiographic way for the skip edge or C0&C1 continual edge which are widely uses in free surface parts. Because the edge detection method can make out measurement path according to the edge curve and optimize measurement points, the laser probe can adaptively measure the parts in a fast and accurate mode. Finally experiments show that the method is effective. And this method can be used to regulation part measurement too.