Abstract:Intersections and discontinuities commonly arise in surface modeling and cause problems in downstream operations. Local geometry repair, such as cover holes or replace bad surfaces by adding new surface patches for dealing with inconsistencies among the confluent region, where multiple surfaces meet, is a common technique used in CAD model repair and reverse engineering. However, local geometry repair destroys the topology of original CAD model and increases the number of surface patches needed for freeform surface shape modeling. Consequently, a topology recovery technique dealing with complex freeform surface model after local geometry repair is proposed. Firstly, construct the curve network which determine the geometry and topology properties of recovery freeform surface model; secondly, apply freeform surface fitting method to create B-spline surface patches to recover the topology of trimmed ones. Corresponding to the two levels of enforcing boundary conditions on a B-spline surface, two solution schemes are presented respectively. In the first solution scheme, non-constrained B-spline surface fitting method is utilized to piecewise recover trimmed confluent surface patches and then employs global beautification technique to smoothly stitch the recovery surface patches. In the other solution scheme, constrained B-spline surface fitting technique based on discretization of boundary conditions is directly applied to recover topology of surface model after local geometry repair while achieving G 1 continuity simultaneously. The presented two different schemes are applied to the consistent surface model, which consists of five trimmed confluent surface patches and a local consistent surface patch, and a machine cover model, respectively. The application results show that our topology recovery technique meets shape-preserving and G 1 continuity requirements in reverse engineering. This research converts the problem of topology recovery for consistent surface model to the problem of constructing G 1 patches from a given curve network, and provides a new idea to model repairing study.

Virtual Measurement in Reverse CAD Modeling of Organ

Semantics-based measurement information transmission method for reverse engineering

A Review of 3-D Geometric Model Reconstruction Methods in Reverse Engineering

An Adaptive Sampling Approach for Digitizing Unknown Free-form Surfaces Based on Advanced Path Detecting

3D Measuring Points Registration Based on Datum-Points in Reverse Engineering

Measurement of deformed surface and key data processing based on reverse engineering

Research on Digital Measure and Data Processing of Complex Surface in RE

Automatical Reconstruction of Deficient Cad Model

Large Surface Fitting and Trimming Techniques for N-sided Regions Filling

A 3-D Point Sets Registration Method in Reverse Engineering

A Representation Model and Modeling Method of 3d Reconstruction Object Supporting Product Redesign

A Study on Free Form Surface Digitization Based on Ultrasonic Distance Measurement

A new research of surfaces reconstruction of revolution in reverse engineering

Research of Assembly Modeling Method for Reverse Engineering

Topology Recovery Technique for Complex Freeform Surface Model after Local Geometry Repair

Topology Recovery Technique for Complex Freeform Surface Model Based on Local Consistent Mending

Study on Measurement Planning of Complex Surface in Reverse Engineering

Global Continuity Adjustment and Local Shape Optimization Technique for Complex Trimmed Surface Model

Object Reconstruction from Geometric Features and Constraints in Reverse Engineering

Geometric Design Model and Object Scanning Mode Based Virtual Assembly and Repair Analysis

Architecture and Key Techniques of Feature-Based Reverse Modeler-Re-soft