Abstract:Reinforced masonry buildings typically have a load-bearing wall structural system. Thus, the reinforced masonry shear walls must be capable of resisting both vertical forces from gravity loads and lateral forces from seismic and wind loads. Typically, because the walls are subjected to high axial loads, ensuring the ductile response becomes challenging. A possible solution at the component level would be the utilization of walls with confined ends (i.e., walls with boundary elements) to reduce the compression zone and increase the compression strain. Another solution, which is at the system level, is the introduction of a hybrid structural system composed of two types of walls: (1) ductile walls with or without boundary elements to resist the lateral forces and part of vertical forces, and (2) gravity walls that resist only axial loads. This paper proposes a combination of both solutions (i.e., at component and system levels). Additionally, it utilizes a series of linear and nonlinear static and dynamic analyses to evaluate and quantify the effect of cross-section configuration and ductile shear wall area to total floor area (i.e., ductile shear wall ratio) on the seismic response of masonry buildings. The numerical analyses are performed by a macro model detailed to simulate the nonlinear response. The primary objective is to recommend a range of ductile shear wall ratios that optimize the design and overall performance. The study targets mid-rise and high-rise masonry buildings located in regions with moderate seismic hazard. The findings emphasize that utilizing the ductile walls with boundary elements in the proposed hybrid structural system resulted in major favorable enhancements in the structural response and optimization of the design. In addition, the results demonstrate the possibility of vertically reducing and terminating the specially detailed boundary elements, thus promoting ductile reinforced concrete masonry shear wall buildings as a competitive building system.

Nonlinear Static Analysis On Masonry Wall Strengthened With Reinforced Mortar Overlay

EXPERIMENT AND NONLINEAR STATIC ANALYSIS OF BRICK MASONRY WALL STRENGTHENED WITH STRAND MESH REINFORCING POLYMER MORTAR OVERLAY

Simulation Of Collapse Process Of Masonry Walls Based On Expanded Discrete Element Method

Analysis on Reinforce Concrete Sandwich Wall-Panel Using Nonlinear Finite Element Method

Nonlinear masonry wall analysis of strengthened with high-strength wire cable and polymer mortar

Analytical modeling of masonry load-bearing walls

ANALYSIS ON THE NONLINEAR BEHAVIOR OF SHEAR RESISTANCE OF REINFORCED CONCRETE MASONRY SHEAR WALL

A 3D Pilot Simulation of Masonry Walls Retrofitted with Steel Strips Using a Novel Meso-Scale Damage-Plasticity Interface Model

Nonlinear static analytical shear-flexure model of RC shear wall structure and its realization

Elasto-Plastic Analysis Of Reinforced Concrete Shear Wall With Openings Using A Macro Model

Nonlinear finite element analysis of prefabricated hollow-core reinforced concrete shear walls

Nonlinear Behavior of a Masonry Subassemblage Before and After Strengthening with Inorganic Matrix-Grid Composites

Nonlinear Static Analysis of Rc Shear Wall Structure Based on Opensees

Nonlinear Analysis of Shear Wall Structures Supported by Fram Using Finite Strip Methoel

In-Plane Strengthening Effect of Prefabricated Concrete Walls on Masonry Structures: Shaking Table Test

Nonlinear Analysis of Masonry Buildings under Seismic Actions with a Multifan Finite Element

Simulation of Masonry Wall using Concrete Damage Plasticity Model

Explicit Approach for the In-Plane Cyclic Behaviors of Unreinforced Masonry Structures Using Finite Particle Method

Shaking table tests and numerical simulation for brick masonry structure reinforced with polypropylene mesh cement mortar coating

Nonlinear finite and discrete element simulations of multi-storey masonry walls

Effect of Ductile Shear Wall Ratio and Cross-Section Configuration on Seismic Behavior of Reinforced Concrete Masonry Shear Wall Buildings