Abstract:BackgroundLoss of Coolant Accidents (LOCAs) is a crucial research topic for nuclear reactor safety analysis, and understanding the thermal–hydraulic behavior of the rod bundle channels during the reflooding stage of a LOCA is essential.PurposeThis study aims to develop theoretical models of the reflooding stage in addition to providing benchmark data for evaluating the safety analysis code for LOCAs in a reactor and for the design of the residual heat removal system.MethodsA series of bottom reflooding tests were conducted on a 5×5 rod bundle in the film boiling test facility at the nuclear safety and operation laboratory (NUSOL) of Xi'an Jiaotong University using uniformly heated rods. The experimental results were analyzed in detail, and the surface parameters of the heated rod bundle were obtained by solving a one-dimensional transient inverse heat conduction problem. The effects of different experimental conditions on the velocity of the quench front propagation were investigated. Furthermore, the experimental results were compared and calculated using the thermal safety analysis code, and the problems with the thermal safety analysis code RELAP5 reflooding simulation are summarized.ResultsOur results indicate that a high inlet flow rate, high inlet subcooling degree, and low power density are favorable for the propagation of the cold front during the reflooding process. Additionally, the root mean square (RMS) error of the simulated quench time and peak cladding temperature (PCT) are 40.994 s and 61.465 K, respectively. However, the simulation results have a relatively large error compared with the experimental results in the post-critical heat flux (CHF) heat transfer stage, primarily owing to the issues with the boiling mode judgment and membrane boiling heat transfer model.ConclusionsThe experimental data of this study can serve as new verification data for flow and heat transfer prediction models during the reflooding process; it can also be used to evaluate and optimize the thermal-hydraulic safety analysis code. Loss of Coolant Accidents (LOCAs) is a crucial research topic for nuclear reactor safety analysis, and understanding the thermal-hydraulic behavior of the rod bundle channels during the reflooding stage of a LOCA is essential.

Analysis Of Flashing And Slow Descending Phenomenon In Ring Coelom Of Integrated Reactor During Loca

Analysis of Effect of Flashing Liquid Jet on Surrounding Instruments During LOCA

Frequency and amplitude of flashing-induced instability in an open natural circulation loop

Severe Accident Progression Analysis Induced by LLOCA at Reactor Outlet Header

EXPERIMENTAL STUDY ON LOW PRESSURE FLOW INSTABILITY

Analyses for Passive Safety of Fusion-Reactor During Ex-Vessel Loss-Of-Coolant Accident

Experimental Study of the Transient Characteristics of A Natural Circulation Loop under Sbloca

Experimental investigation of bottom reflooding for uniformly heated 5×5 rod bundles and evaluation of thermal safety analysis code

A Transient Fluid–structure Interaction Analysis Strategy and Validation of a Pressurized Reactor with Regard to Loss-of-coolant Accidents

CFD modelling of flashing flows for nuclear safety analysis: possibilities and challenges

A Study on Natural Circulation Flow under Reactor Cavity Flooding Condition in Advanced PWR

Critical Mass Flux of Subcooled Liquid Leakage in a Nuclear Plant

Multi-scale coupling analysis of the flow blockage accident in the typical LFR

Experimental and Numerical Investigation of Sub-Cooled Boiling, Condensation, and Void Flashing in Nuclear Heating Reactor Test Loop

Numerical Simulation of AP1000 LBLOCA with SCDAP/RELAP 4.0 Code

Study on the Lower Head Failure in Severe Accidents Part II: Thermal-mechanical Coupling Behavior Analysis on CAP1400 Reactor Lower Head

Parametric Analysis of Influence Factors to the In-Vacuum Vessel Loca for Cfetr Based on Relap5

Thermal-Hydraulic Analysis of the Upper Plenum in a Typical LFR During a Reactivity Insertion Accident

Improvement of Reflood Model in RELAP5 Code Based on Sensitivity Analysis

CFD simulation on the transient process of coolant mixing phenomenon in reactor pressure vessel

Investigation on Structural Behaviors of Reactor Pressure Vessel with the Effects of Critical Heat Flux and Internal Pressure