Abstract:Recently, deepwater resource exploration has grown rapidly. Because the conditions of marine environment and seabed geology are more complex, deepwater drilling needs to numerous confront challenges, such as more complicated wellbore situations, low drilling efficiency, and high cost. Advanced novel drilling methods serve as significant impetus to facilitate the rapid advancement in deepwater oil-and-gas exploration and development. However, adopting riserless drilling methods may pollute marine environment and yield poor wall protective effects, while drilling methods with risers may suffer from relatively high cost and risk. Based on these dilemmas, in this study, a novel deepwater closed-cycle riserless drilling method with a subsea pump + gas combined lift is proposed. The proposed novel closed-cycle method has also established a multiphase flow drilling model and analyzed the effects of drilling fluid displacement, gas injection displacement, gas injection site and seawater depth on the multiphase flow in the wellbore. The simulation results revealed the following: As the gas migrates upward along the pipeline, its flow velocity first increases slowly and then rapidly owing to the volume expansion of gas. Larger displacement of drilling fluid demands greater working power of the subsea lifting pump, which is characterized by a nonlinear relationship. The gas injection displacement can effectively mitigate the load-bearing capacity of the pump, and increasing gas injection displacement leads to a decreased subsea lifting pump working power requirement; the decreasing effect on pump power load is more significant in the case of low gas injection displacement. Increasing the depth of gas injection sites reduces the subsea pump working with a decreasing slope with respect to the power descent. Finally, the subsea pump lifting power demand increases approximately linearly with an increasing seawater depth. Subsequently, an optimization method of hydraulic parameters for deepwater closed-cycle riserless drilling was proposed, which provides a theoretical foundation for the selection of subsea pumping power as well as the optimization of gas injection sites and displacement.

Heat Radiation Research And Optimized Analysis Of Burner Boom On Semi-Submersible Drilling Platform

Structural Response Analysis of FPSO under Pool Fire

Numerical simulation analysis of a heat transfer tube in SuperORV

Experimental and numerical study of gas explosion from semi-submersible platform

Numerical study on the temporal and spatial distribution law of natural gas explosion load on an ultra-deepwater semi-submersible drilling platform

Load Characteristics in Process Modules of Offshore Platforms under Jet Fire: the Numerical Study

Research on the Temperature Distribution in Electrically Heated Offshore Heavy Oil Wellbores

Explosion risk-based water spray mitigation analysis of ultra-deep-water semi-submersible platforms

Experimental study on fire suppression performance of the high pressure water mist in the engine room of an offshore platform

An improved thermal model for predicting wellbore temperature distribution in deep-water gas well

Wellbore Temperature Field Prediction in Marine Drilling

Experimental study on the burning rate and flame dynamics of oil reservoir pool fire under cross-wind: Effect of lip height

Analysis on Heat Transfer and Steam Injection in the Wellbore and Calculation on Heat Loss

Quantitative Risk Analysis of Oil and Gas Fires and Explosions for FPSO Systems in China

Gas-Flow-Rate Inversion Based on Experiments and Simulation of Flame Combustion Characteristics in a Drilling Blowout

Simulation and Analysis of Multiphase Flow in a Novel Deepwater Closed-Cycle Riserless Drilling Method With a Subsea pump+gas Combined Lift

A Real-Time Calculation Method to Improve Boiler Safety in Deep Peak Shaving Cases

Field Scale Combustion Simulation Studies — Investigation of Reservoir Fluid and Operational Parameters on Project Performance

Numerical analysis of heat transfer rate and wellbore temperature distribution under different circulating modes of Reel-well drilling

An Investigation of Rotary Cup Burner Assembly with Three Vehicle-Mounted Cooking Stoves by Numerical Evaluation Method

Design and numerical study of active cooling system of measurement while drilling for high temperature based on supersonic