Abstract:In recent years, significant breakthroughs have been made in the exploration of deep to ultra-deep oil and gas reserves onshore in China. These conventional deep to ultra-deep reservoirs are typically buried at depths exceeding 4500 m, with bottom-hole temperatures surpassing 150 °C. The high temperatures at the bottom of the well are more likely to cause deterioration in drilling fluid properties, altering its rheological properties and reducing cutting transport efficiency, which can lead to wellbore cleaning issues. In this paper, the numerical simulation method is used to analyze the influence of cutting particle size, drilling fluid flow rate, drill pipe rotation speed, and drill pipe eccentricity on the annular cutting concentration under different wellbore drilling fluid temperature conditions. The results show that at the same cutting particle size, as the drilling fluid temperature increases, the cutting concentration in the annulus increases sharply. The increase is the largest when the particle size is 3 mm, and when the drilling fluid temperature is 220 °C, the cutting concentration increases by 79.7% compared to at 200 °C and by 279% compared to at 180 °C. When the flow rate increases from 0.5 m/s to 1.0 m/s, the annular cutting concentration at drilling fluid temperatures of 220 °C and 200 °C decreases by 70.5% and 50.4%, respectively. The higher the drilling fluid temperature, the better the cutting removal effect when increasing the drill pipe rotation speed. However, when the rotation speed exceeds 120 rpm, the change in cutting concentration with increasing rotation speed becomes insignificant. When the drill pipe eccentricity is small, an increase in drilling fluid temperature leads to a significant rise in annular cutting concentration. However, when the drill pipe eccentricity is large, changes in drilling fluid temperature have a smaller impact on cutting concentration. The research findings can provide engineering guidance and theoretical support for the design of drilling fluid hydraulic parameters for cutting transport and rheological parameters in high-temperature wellbores.

Numerical analysis of heat transfer rate and wellbore temperature distribution under different circulating modes of Reel-well drilling

Thermal behavior prediction and adaptation analysis of a reelwell drilling method for closed-loop geothermal system

Research on thermal behavior of ultra-deep horizontal well drilling with dual-channel drillpipe

A Transient Analytical Model for Predicting Wellbore/Reservoir Temperature and Stresses during Drilling with Fluid Circulation

Development and application of wellbore heat transfer model considering variable mass flow

Study on Non-Isothermal Three-Phase Flow Characteristics in Large-Diameter Drilling Annular

Wellbore-heat-transfer-model-based optimization and control for cooling downhole drilling fluid

Downhole heat management for drilling shallow and ultra-deep high enthalpy geothermal wells

Influence of the location of drilling fluid loss on wellbore temperature distribution during drilling

Wellbore Temperature Field Prediction in Marine Drilling

Numerical Simulation of Natural Convection and Calculation of Heat Transfer Coefficient in Wellbore Annulus during Deep-Water Gas Well Testing

Design and numerical study of active cooling system of measurement while drilling for high temperature based on supersonic

An improved thermal model for predicting wellbore temperature distribution in deep-water gas well

A new two-dimensional transient forecast model of wellbore temperature based on precise time step integration method

A Numerical Simulation of the Effect of Drilling Fluid Rheology on Cutting Migration in Horizontal Wells at Different Drilling Fluid Temperatures

A Model for Downhole Fluid and Rock Temperature Prediction During Circulation

Study of the Heat Transfer in the Wellbore During Acid/Hydraulic Fracturing Using a Semianalytical Transient Model

A new detection method of co-existence of well kick and loss circulation based on thermal behavior of wellbore-formation coupled system

Fully transient coupled prediction model of wellbore temperature and pressure for multi-phase flow during underbalanced drilling

Study on temperature distribution along wellbore of fracturing horizontal wells in oil reservoir

Simulation study of drilling fluid cooling in long horizontal wells based on phase change heat absorption