Abstract:Diesel engine emissions for on-road, stationary and marine applications are regulated in the United States via standards set by the Environmental Protection Agency (EPA). A major component of diesel exhaust that is difficult to reduce is nitrogen oxides (NOx). Selective catalytic reduction (SCR) has been in use for many years for stationary applications, including external combustion boilers, and is promising for NOx abatement as a retrofit for mobile applications where diesel compression ignition engines are used. The research presented in this paper is the first phase of a program focused on the reduction of NOx by use of a stand-alone urea injection system, applicable to marine diesel engines typical of work boats (e.g., tugs). Most current urea SCR systems communicate with engine controls to predict NOx emissions based on signals such as torque and engine speed, however many marine engines in use still employ mechanical injection technology and lack electronic communication abilities. The system developed and discussed in this paper controls NOx emissions independentof engine operating parameters and measures NOx and exhaust flow using the following exhaust sensor inputs: absolute pressure, differential pressure, temperature, and NOx concentration. These sensor inputs were integrated into an independent controller and open loop architecture to estimate the necessary amount of urea needed, and the controller uses pulse width modulation (PWM) to power an automotive fuel injector for airless urea delivery. The system was tested in a transient test cell on a 350 hp engine certified at 4 g/bhp-hr of NOx, with a goal of reducing the engine out NOx levels by 50%. NOx reduction capabilities of 41-67% were shown on the non road transient cycle (NRTC) and ICOMIA E5 steady state cycles with system optimization during testing to minimize the dilute ammonia slip to cycle averages of 5-7 ppm. The goal of 50% reduction of NOx can be achieved dependent upon cycle. Further research with control optimization, urea distribution and possible use of oxidation catalysts is recommended to improve the NOx reduction capabilities while minimizing ammonia slip.

Urea powerful mixing device for SCR system of small and medium-sized ship

Fluid Mixing Optimization Strategy of Catalytic Reactor for Marine SCR System

SCR (selective catalytic reduction) system for small and medium-sized ships

Optimizing Flow Field in an SCR System of a 600 MW Power Plant: Effects of Static Mixer Alignment Style

Urea control system of SCR reactor

Selective catalytic reduction denitrification facility suitable for middle -size and small -size boats and ships

Spraying and Mixing Characteristics of Urea in a Static Mixer Applied Marine SCR System

Hybrid system is imitated by force to urea

Highly Efficient and Economical Nitrogen Oxides Controlled by an In‐furnace Urea Solution Pyrolysis Coupled with SCR System for a Coal‐fired Utility Boiler

Experiment and Simulation of Ammonia Distribution Uniformity for Diesel Engine Urea-SCR

Ship tail gas washing and purifying system and method suitable for complex swing/start-stop working conditions

Intelligent ammonia injection control system suitable for full load

Urea Injection and Uniformity of Ammonia Distribution in SCR System of Diesel Engine

Design and Numerical Simulation Study of Diesel Engine Urea-SCR System's Mixer

System and method for preventing high-viscosity ash from being deposited on surface of catalyst through multi-element reinforced coupling intelligent regulation and control

Experimental investigation of urea injection strategy for close-coupled SCR aftertreatment system to meet ultra-low NO<i><sub>x</sub></i> emission regulation

Simultaneous removal of SO2 and NOx from flue gas by wet scrubbing using a urea solution

Ship tail gas purification device

Design and testing of an independently controlled urea SCR retrofit system for the reduction of NOx emissions from marine diesels

Ammonia coverage ratio control of a novel two-cell SCR-DeNOX system configuration based on IA-ISMC

Evaluation system for testing performance of selective catalytic reduction (SCR) denitration catalyst