Abstract:Mordenite composite membranes were prepared by means of coating a porous α-alumina support with nanosized mordenite seeds followed by hydrothermal crystallization. A systematic investigation was performed on the influence of several factors such as ageing of the reaction mixture, alkalinity, salt addition and temperature on the formation of a mordenite membrane on the seeded support. The ageing of the reaction mixture reduces the growth rate of mordenite crystal along a-axis and b-axis but hardly influences the growth rate along c-axis. As a result, the boundaries between the surface crystals become a little larger with prolonging the period of ageing time. The growth rate of the mordenite crystal along individual axes increases first and then decreases with increasing concentration of sodium hydroxide. A higher alkalinity is unfavorable for the formation of a continuous mordenite membrane. The addition of salt in the reaction mixture has different effect on the growth rate of the mordenite crystal along each axis. With increasing the amount of salt, there was hardly influence on the growth rate along c-axis, whereas an obvious decline was observed in the growth rate along either a-axis or b-axis, which enlarges the boundaries between the surface crystals. The growth rate of the mordenite crystal increases more along c-axis than that along a-axis or b-axis with increasing temperature for hydrothermal crystallization. The use of a temperature as high as 473 K produces a membrane composed of bar-like crystals with larger boundaries.

Preparation and humidity control performance of aluminum containing mesoporous molecular sieve synthesis from liquid crystal display waste glass and sandblasting waste

Functionalization of Mesoporous Al-MCM-41 for Indoor Humidity Control as Building Humidity Conditioning Material

Preparation of Mordenite Composite Membranes with Seeding

Utilization of waste from the silicon carbide grinding sludge and stone sludge as source of silicon aluminum for the synthesis of the amine functional mesoporous humidity control material

Synthesis of MCM-41 mesoporous molecular sieve based on recycled glass fibers from waste fan blades

The Synthesis of Mesoporous Molecular Sieve MCM-48

Preparation of Mesoporous Molecular Sieves Al-Msu-S Using Ionic Liquids As Template

The Effect of Water Content on the Preparation of Mesoporous Monoliths and Films

Influence of cations (Li+, Na+, K+)for synthesis mesoporous molecular sieve MCM-41 and their properties

A Reliable Synthesis of Cubic Mesoporous MCM-48 Molecular Sieve

Synthesis of Mesoporous Molecular Sieves with Secondary Building Units of Y Zeolite by Using Surfactants in Low Concentration as Template

Preparation of ZSM-5 molecular sieve by diatomaceous earth in-situ crystallization

Synthesis and Characterization of Ordered Mesoporous Aluminosilicate Molecular Sieves with High Stability in High-Temperature Steam

Insights into formation and properties of amorphous mesostructured alumina

Temperature-Driven Structural Evolution during Preparation of MCM-41 Mesoporous Silica

Improvement of Hydrothermal Stability of an Ordered Mesoporous Molecular Sieve Via Multistage Recrystallization

SYNTHESIS OF MESOPOROUS MOLECULAR SIEVES WITH SECONDARY BUILDING UNITS OF β ZEOLITE AT LOW SURFACTANT CONCENTRATION

Optimization of synthesis parameters for the preparation of zeolite by reusing industrialwaste as raw material: Sandblasting waste and solar panel waste glass

Preparation of MCM-41 with high thermal stability and complementary textural porosity

Synthesis and characterization of ordered mesoporous aluminosilicates molecular sieves with highly hydrothermal stability

Transformation of Lamellar Silicate into the Mesoporous Molecular Sieve MCM-41