Abstract:Zhundong coal, high-quality coal with large reserves in China, faces great challenges on its large-scale utilization in utility boilers due to the ash-related problems caused by high alkali and alkali earth metals (AAEMs). In this research, to simulate ash deposition behavior on heating surfaces in high temperature flue gas zone (panel superheater) and that in medium-temperature flue gas zone (superheater or reheater), deposition experiments were carried out during Zhundong coal combustion in a drop tube furnace (DTF) at the deposition temperature of 1200 degrees C and 900 degrees C. Meanwhile, water leaching, Na2CO3 additive and kaolin additive were employed to elucidate the formation mechanism of ash deposition and alleviate deposition and slagging. Results showed that leaching reduced the contents of troublesome elements such as AAEMs and S and increased the relative contents of Si and Al, thus alleviating ash deposition. Compared with raw coal, the deposition rate of leached coal decreased from 5.82 mg h(-1) cm(-2) to 0.88 mg h(-1) cm(-2) at the deposition temperature of 900 degrees C. The primary reason for the decreased deposition rate might be that the dominant minerals in leached coal ash were refractory SiO2, CaO and Ca2SiO4. The addition of Na2CO3 would aggravate the slagging and fouling on the deposition surface significantly. The gaseous Na2O decomposed from Na2CO3 reacted with SO2 and SiO2 in the flue gas to form low-melting Na2SO4 and Na2Si3O7, which were easy to cause severe slagging on the deposition surface. The inhibition effect of kaolin addition on the formation of deposition and slagging was similar to that of leaching. After the addition of kaolin, the dominant compounds of fly ash altering to high-melting minerals such as CaSiO3, CaSO4, Ca2MgSi2O7 and NaCaAlSi2O7, resulting in a lower deposition rate than raw coal. Besides, when deposition temperature increased from 900 degrees C to 1200 degrees C the slagging degree of deposition surfaces was aggravated, while the deposition rate of four fuels followed different change trends. Specifically, the deposition rate of raw coal and leached coal decreased, whereas that of the case with Na additive and kaolin additive presented an increasing trend. At last, the role of water leaching and additives on the formation of ash deposition during Zhundong coal combustion was clarified. (C) 2020 Energy Institute. Published by Elsevier Ltd. All rights reserved.

The Adsorption Mechanism of Heavy Metals from Coal Combustion by Modified Kaolin: Experimental and Theoretical Studies.

Effect of alkaline metals (Na, Ca) on heavy metals adsorption by kaolinite during coal combustion: Experimental and DFT studies

Effects of modified kaolin adsorbents on sodium adsorption efficiency and ash fusion characteristics during Zhundong coal combustion

First principles insights into the interaction mechanism of iron doped thermally activated kaolinite with Cd and Pb pollutants in organic solid waste incineration flue gas

The Influence of Multi-Step Modification Method on the Adsorption Effect of Alkali Metal Adsorbent in High Temperature Corrosive Environment

Effect of modified Ca-Al adsorbents on heavy metal fixation during co-combustion of coal and coconut shells: Experiments and simulations

Experiment and Mechanism Study on the Effect of Kaolin on Melting Characteristics of Zhundong Coal Ash

Thermal activated-acid/alkali modified kaolin for enhanced heavy metals capture during high-organic solid waste pyrolysis: Experimental and theoretical comparative study

Optimal metal immobilization of oxygen-enriched co-combustion of Zn/Cd hyperaccumulator and textile dyeing sludge with natural or modified kaolin

Study on the Mechanism of Lead Incorporation into Minerals During High-Temperature Coal Combustion

Comparative study on intercalation-exfoliation and thermal activation modified kaolin for heavy metals immobilization during high-organic solid waste pyrolysis

Dynamic and static insights on the interaction mechanism between heavy metal contaminants in MSW incineration flue gas and modified carbon materials: Aggregation of PbO and CdO

Experimental study on enrichment of heavy metals by modified mullite during co-combustion of lignite with eucalyptus wood

Effect of calcined kaolin on PM0.4 formation from combustion of Zhundong lignite

Migration and transformation mechanisms of Pb/Cd with HCl in organic solid waste incineration flue gas on the composite-modified kaolinite surface

Experimental research on the gaseous PbCl 2 adsorption by thermal alkali modified coal fly ash

Reduction of heavy metal emissions by adding modified attapulgite to sludge in bubbling fluidized bed incineration process

Effects of Leaching and Additives on the Formation of Deposits on the Heating Surface During High-Na/ca Zhundong Coal Combustion

Experimental research on the content and transformation of alkali/alkaline earth metals in Zhundong-Wucaiwan coal

Experimental and mechanistic study on the enrichment of heavy metals by modified calcium oxide during MSW pyrolysis

Synthesis of coal-analcime composite from coal gangue and its adsorption performance on heavy metal ions