Abstract:Zhundong coal, high-quality coal with large reserves in China, faces great challenges on its large-scale utilization in utility boilers due to the ash-related problems caused by high alkali and alkali earth metals (AAEMs). In this research, to simulate ash deposition behavior on heating surfaces in high temperature flue gas zone (panel superheater) and that in medium-temperature flue gas zone (superheater or reheater), deposition experiments were carried out during Zhundong coal combustion in a drop tube furnace (DTF) at the deposition temperature of 1200 degrees C and 900 degrees C. Meanwhile, water leaching, Na2CO3 additive and kaolin additive were employed to elucidate the formation mechanism of ash deposition and alleviate deposition and slagging. Results showed that leaching reduced the contents of troublesome elements such as AAEMs and S and increased the relative contents of Si and Al, thus alleviating ash deposition. Compared with raw coal, the deposition rate of leached coal decreased from 5.82 mg h(-1) cm(-2) to 0.88 mg h(-1) cm(-2) at the deposition temperature of 900 degrees C. The primary reason for the decreased deposition rate might be that the dominant minerals in leached coal ash were refractory SiO2, CaO and Ca2SiO4. The addition of Na2CO3 would aggravate the slagging and fouling on the deposition surface significantly. The gaseous Na2O decomposed from Na2CO3 reacted with SO2 and SiO2 in the flue gas to form low-melting Na2SO4 and Na2Si3O7, which were easy to cause severe slagging on the deposition surface. The inhibition effect of kaolin addition on the formation of deposition and slagging was similar to that of leaching. After the addition of kaolin, the dominant compounds of fly ash altering to high-melting minerals such as CaSiO3, CaSO4, Ca2MgSi2O7 and NaCaAlSi2O7, resulting in a lower deposition rate than raw coal. Besides, when deposition temperature increased from 900 degrees C to 1200 degrees C the slagging degree of deposition surfaces was aggravated, while the deposition rate of four fuels followed different change trends. Specifically, the deposition rate of raw coal and leached coal decreased, whereas that of the case with Na additive and kaolin additive presented an increasing trend. At last, the role of water leaching and additives on the formation of ash deposition during Zhundong coal combustion was clarified. (C) 2020 Energy Institute. Published by Elsevier Ltd. All rights reserved.

Effect of calcined kaolin on PM0.4 formation from combustion of Zhundong lignite

Ultrafine particulate matter formation in the early stage of pulverized coal combustion of high-sodium lignite

Effects of modified kaolin adsorbents on sodium adsorption efficiency and ash fusion characteristics during Zhundong coal combustion

Sulfate Removal by Kaolin Addition To Address Fouling in a Full-Scale Furnace Burning High-Alkaline Zhundong Coal

Influence of kaolin on sodium retention and ash fusion characteristic during combustion of Zhundong coal

Effects of H2o and Hcl on Particulate Matter Reduction by Kaolin under Oxy-Coal Combustion

Experiment and Mechanism Study on the Effect of Kaolin on Melting Characteristics of Zhundong Coal Ash

Fate of Na/As along the flue gas path during coal combustion with kaolin addition

Effect of External Mineral Addition on PM Generated from Zhundong Coal Combustion

Characteristic of Particulate Matter from Combustion of Zhundong Lignite: A Comparison Between Air and Oxy-fuel Atmospheres

Effect of Na/Ca/Fe on Slagging Behavior of Zhundong Coal During Combustion Process

The effect on ash deposition by blending high‐calcium Zhundong coal with vermiculite: Focusing on minerals transformations

Effect of Kaolin on the Thermal Conversion Performance of Zhundong Sub-bituminous Coal

Effects of leaching and additives on the ash fusion characteristics of high-Na/Ca Zhundong coal

Evolution of Particulate Matter in the Post-Combustion Zone of Zhundong Lignite

Effects of Minerals Containing Sodium, Calcium, and Iron on Oxy-Fuel Combustion Reactivity and Kinetics of Zhundong Coal Via Synthetic Coal

Effects of Leaching and Additives on the Formation of Deposits on the Heating Surface During High-Na/ca Zhundong Coal Combustion

Characteristics of Fine Particulate Matter Formation During Combustion of Lignite Riched in AAEM (alkali and Alkaline Earth Metals) and Sulfur

Effects of Temperature and Chemical Speciation of Mineral Elements on PM10 Formation during Zhundong Coal Combustion

Investigation on PM Formation from Combustion of Lignite with High Contents of AAEMs (alkali and Alkaline Earth Metals) and Fe: Effect of the Reaction Temperature

THE EFFECT OF CALCIUM-BEARING MINERAL ON ASH MELTING BEHAVIOR DURING ZHUNDONG COAL COMBUSTION